No abstract

No abstract

No abstract

Purpose The purpose of this paper is to investigate a cylindrical flow insert for a parabolic trough solar collector. Centrally placed and eccentric placed inserts are investigated in a systematic way to determine which configuration leads to the maximum thermal enhancement. Design/methodology/approach The analysis is performed in SolidWorks Flow Simulation with a validated computational fluid dynamics model. Moreover, the useful heat production and the pumping work demand increase are evaluated using the exergy and the overall efficiency criteria. The different scenarios are compared for inlet temperature of 600 K, flow rate of 100 L/min and Syltherm 800 as the working fluid. Moreover, the inlet temperature is examined from 450 to 650 K, and the diameter of the insert is investigated up to 50 mm. Findings According to the final results, the use of a cylindrical insert of 30 mm diameter is the most sustainable choice which leads to 0.56 per cent thermal efficiency enhancement. This insert was examined in various eccentric positions, and it is found that the optimum location is 10 mm over the initial position in the vertical direction. The thermal enhancement, in this case, is about 0.69 per cent. The pumping work demand was increased about three times with the insert of 30 mm, but the absolute values of this parameter are too low compared to the useful heat production. So, it is proved that the increase in the pumping work is not able to eliminate the useful heat production increase. Moreover, the thermal enhancement is found to be greater at higher temperature levels and can reach up to 1 per cent for an inlet temperature of r650 K. Originality/value The present work is a systematic investigation of the cylindrical flow insert in a parabolic trough collector. Different diameters of this insert, as well as different positions in two dimensions, are examined using a parametrization of angle-radius. To the authors’ knowledge, there is no other study in the literature that investigates the presented many cases systematically with the followed methodology on parabolic trough collectors. Moreover, the results of this work are evaluated with various criteria (thermal, exergy and overall efficiency), something which is not found in the literature.

The objective of this study is to determine the energetic and exergetic enhancement of parabolic trough collector with internal fins in the absorber. Carbon dioxide is the examined working fluid to investigate the performance of the system in high temperature levels. In the first part of this study, the impact of the mass flow rate on the collector performance is analyzed and finally 0.20 kg/s is selected as the most appropriate mass flow rate exergetically. In the second part, the impact of internal fins on the system performance is investigated for operation with the optimum mass flow rate. More specifically, the absorber without fins is compared with three different fins with lengths 5, 10 and 15 mm. The final results prove that the higher fin length increases the thermal performance, while the optimum fin length exergetically is 10 mm with 45.95% exergetic efficiency when the inlet temperature is equal to 400°C. The impact of the pressure losses along the collector is taken into account in the exergetic efficiency, which is the best index for evaluating solar collectors operating with gases. The analysis is performed with Solidworks Flow Simulation, a powerful tool which allows the simultaneous thermal and optical analysis.