The review is devoted to the analysis of the compositional disordering potential of the crystal matrix of a scintillator to improve its scintillation parameters. Technological capabilities to complicate crystal matrices both in anionic and cationic sublattices of a variety of compounds are examined. The effects of the disorder at nano-level on the landscape at the bottom of the conduction band, which is adjacent to the band gap, have been discussed. The ways to control the composition of polycationic compounds when creating precursors, the role of disorder in the anionic sublattice in alkali halide compounds, a positive role of Gd based matrices on scintillation properties, and the control of the heterovalent state of the activator by creation of disorder in silicates have been considered as well. The benefits of introducing a 3D printing method, which is prospective for the engineering and production of scintillators at the nanoscale level, have been manifested.

No abstract

A mechanism of firefly high‐scintillation light yield (LY) of Tb‐doped quaternary (Gd, Y)3Al2Ga3O12 garnet ceramics is reported. Through measurements with the synchrotron source, the high efficiency of the luminescence excitation, providing a quantum yield Q > 1 below the photon multiplication energy range, is defined. The excitation efficiency reaches two at the excitation energy slightly above 2Eg. The cascade of photons is explained by combining three factors: first, the high quantum yield Q ≈ 1 of the luminescence at excitation in lower mixed states 4f75d1 with high spin (HS) and low spin (LS); second, the cross‐relaxation 4f7(6P)5d1(HS) → 4f7(8S)5d1(HS) provides the excitation of 4f8(7F0) →4f8(5D1,4) transition of the 4f8 configuration of the same or neighboring Tb ion, which is followed by the luminescence from 5D1,4; and finally, the relaxation of 4f7(8S)5d1‐5(HS) configuration into the excited 4f8 configuration occurs with future emission from 4f8(5D1,4) states. This cascade forms the final stage of the scintillation in the compound being studied and provides a LY twice as high compared with the material when doped with Ce.

No abstract

In the present article, the influence of the activator concentration and impurity content of raw materials on the luminescence and scintillation properties of Li2CaSiO4 was studied. Polycrystalline powder material was obtained by the sol–gel method. It was shown that europium had limited solubility in the host lattice with a limiting concentration proximate to 0.014 formula units. The maximum intensity of photoluminescence was observed with a divalent europium concentration of 0.002 formula units; the light yield under alpha-particle excitation was measured to be 21,600 photons/MeV for ~200 μm of coating, and under neutron excitation, it was calculated to be 103,800 photons/n, the scintillation kinetics was characterized by an effective decay time of 157 ns. These properties and the transparency in the visible spectrum make it possible to produce scintillation screens with a coating of Li2CaSiO4 for detecting neutrons, alpha particles and low-energy beta radiation. The low Zeff (~15) of this compound makes it less sensitive to gamma rays. The 480 nm blue emission peak makes this material compatible with most commercial PMT photocathodes, CCD cameras and silicon photomultipliers, which have a maximum quantum efficiency in the blue–green spectral region.