The aim of this work was to investigate the effect of phenolic acids on cell membrane permeability of lactic acid bacteria from wine. Several phenolic acids were tested for their effects on the cell membrane of Oenococcus oeni and Lactobacillus hilgardii by measuring potassium and phosphate efflux, proton influx and by assessing culture viability employing a fluorescence technique based on membrane integrity. The experimental results indicate that hydroxycinnamic acids (p-coumaric, caffeic and ferulic acids) induce greater ion leakages and higher proton influx than hydroxybenzoic acids (p-hydroxibenzoic, protocatechuic, gallic, vanillic, and syringic acids). Among the hydroxycinnamic acids, p-coumaric acid showed the strongest effect. Moreover, the exposure of cells to phenolic acids caused a significant decrease in cell culture viability, as measured by the fluorescence assay, in both tested strains. The results agree with previous results obtained in growth experiments with the same strains. Generally, phenolic acids increased the cell membrane permeability in lactic acid bacteria from wine. The different effects of phenolic acids on membrane permeability could be related to differences in their structure and lipophilic character.

A flow system with a multi-channel peristaltic pump placed before the solenoid valves is proposed to overcome some limitations attributed to multi-commuted flow injection systems: the negative pressure can lead to the formation of unwanted air bubbles and limits the use of devices for separation processes (gas diffusion, dialysis or ion-exchange). The proposed approach was applied to the colorimetric determination of ammonium nitrogen. In alkaline medium, ammonium is converted into ammonia, which diffuses over the membrane, causing a pH change and subsequently a colour change in the acceptor stream (bromothymol blue solution). The system allowed the re-circulation of the acceptor solution and was applied to ammonium determination in surface and tap water, providing relative standard deviations lower than 1.5%. A stopped flow approach in the acceptor stream was adopted to attain a low quantification limit (42 microgL(-1)) and a linear dynamic range of 50-1000 microgL(-1) with a determination rate of 20 h(-1).

Total antioxidant capacity assays are recognized as instrumental to establish antioxidant status of biological samples, however the varying experimental conditions result in conclusions that may not be transposable to other settings. After selection of the complexing agent, reagent addition order, buffer type and concentration, copper reducing assays were adapted to a high-throughput scheme and validated using model biological antioxidant compounds of ascorbic acid, Trolox (a soluble analogue of vitamin E), uric acid and glutathione. A critical comparison was made based on real samples including NIST-909c human serum certified sample, and five study samples. The validated method provided linear range up to 100 µM Trolox, (limit of detection 2.3 µM; limit of quantification 7.7 µM) with recovery results above 85% and precision <5%. The validated developed method with an increased sensitivity is a sound choice for assessment of TAC in serum samples.

A sequential injection system with dual analytical line was developed and applied in the comparison of two different detection systems viz; a conventional spectrophotometer with a commercial flow cell, and a multi-reflective flow cell coupled with a photometric detector under the same experimental conditions. The study was based on the spectrophotometric determination of phosphate using the molybdenum-blue chemistry. The two alternative flow cells were compared in terms of their response to variation of sample salinity, susceptibility to interferences and to refractive index changes. The developed method was applied to the determination of phosphate in natural waters (estuarine, river, well and ground waters). The achieved detection limit (0.007 μM PO(4)(3-)) is consistent with the requirement of the target water samples, and a wide quantification range (0.024-9.5 μM) was achieved using both detection systems.

A review on flow analysis with turbidimetric and nephelometric detection is presented. A brief discussion of the principles of turbidimetry and nephelometry is given. Particular emphasis is devoted to coupling different flow techniques (flow injection, sequential injection, multicommutation) to these detection techniques. Applications in environmental, pharmaceutical, biological, and food samples are summarized and compared in terms of application range, flow configuration, repeatability, and sampling rate.

No abstract

No abstract

A flow injection method was developed for the sequential enzymatic determination of ethanol and glycerol in wines, using immobilised ethanol dehydrogenase and glycerol dehydrogenase, respectively. The enzymes were immobilised separately on alkylaminated controlled pore glass. A multi-site spectrophotometric detection system was used in parallel configuration to monitor the absorbance change in the two independent analytical channels. A 50-fold dilution of the samples was necessary before injection. The working range was between 0.05 and 0.5% (v/v) for the ethanol and between 0.03 and 0.3 g l −1 for the glycerol determination, with corresponding detection limits of 2×10 −3 % (v/v) and 2×10 −3 g l −1 . Relative standard deviations (R.S.D.) (n=9) lower than 2.3% for the ethanol and 2.1% for the glycerol determination were found. For 13 samples of different types of table and Port wines, the results showed good agreement with the corresponding reference procedures; a two level recovery study also showed good accuracy for the developed methods. The sampling rate was 10 h −1 , corresponding to 20 determinations per hour.