Incorrect threading of the sequence in the published structures of beta-Lg affects four of the nine beta strands. The basic lipocalin fold of the polypeptide chain is unchanged, however. The relative orientation of the monomers in the beta-Lg dimer differs in the two lattices. On raising the pH, there is a rotation of approximately 5 degrees, which breaks a number of intersubunit hydrogen bonds. It is not yet clear, however, why the stability of the structure should depend so heavily upon the external loop around residue 64 or the beta strand with the free thiol, each of which shows genetic variation.

The mass density of proteins is a relevant basic biophysical quantity. It is also a useful input parameter, for example, for three-dimensional structure determination by protein crystallography and studies of protein oligomers in solution by analytic ultracentrifugation. We have performed a critical analysis of published, theoretical, and experimental investigations about this issue and concluded that the average density of proteins is not a constant as often assumed. For proteins with a molecular weight below 20 kDa, the average density exhibits a positive deviation that increases for decreasing molecular weight. A simple molecularweight-depending function is proposed that provides a more accurate estimate of the average protein density.

This paper describes a new and simple method to determine the molecular weight of proteins in dilute solution, with an error smaller than ∼10%, by using the experimental data of a single small‐angle X‐ray scattering (SAXS) curve measured on a relative scale. This procedure does not require the measurement of SAXS intensity on an absolute scale and does not involve a comparison with another SAXS curve determined from a known standard protein. The proposed procedure can be applied to monodisperse systems of proteins in dilute solution, either in monomeric or multimeric state, and it has been successfully tested on SAXS data experimentally determined for proteins with known molecular weights. It is shown here that the molecular weights determined by this procedure deviate from the known values by less than 10% in each case and the average error for the test set of 21 proteins was 5.3%. Importantly, this method allows for an unambiguous determination of the multimeric state of proteins with known molecular weights.

BackgroundIn recent years, biorefining of lignocellulosic biomass to produce multi-products such as ethanol and other biomaterials has become a dynamic research area. Pretreatment technologies that fractionate sugarcane bagasse are essential for the successful use of this feedstock in ethanol production. In this paper, we investigate modifications in the morphology and chemical composition of sugarcane bagasse submitted to a two-step treatment, using diluted acid followed by a delignification process with increasing sodium hydroxide concentrations. Detailed chemical and morphological characterization of the samples after each pretreatment condition, studied by high performance liquid chromatography, solid-state nuclear magnetic resonance, diffuse reflectance Fourier transformed infrared spectroscopy and scanning electron microscopy, is reported, together with sample crystallinity and enzymatic digestibility.ResultsChemical composition analysis performed on samples obtained after different pretreatment conditions showed that up to 96% and 85% of hemicellulose and lignin fractions, respectively, were removed by this two-step method when sodium hydroxide concentrations of 1% (m/v) or higher were used. The efficient lignin removal resulted in an enhanced hydrolysis yield reaching values around 100%. Considering the cellulose loss due to the pretreatment (maximum of 30%, depending on the process), the total cellulose conversion increases significantly from 22.0% (value for the untreated bagasse) to 72.4%. The delignification process, with consequent increase in the cellulose to lignin ratio, is also clearly observed by nuclear magnetic resonance and diffuse reflectance Fourier transformed infrared spectroscopy experiments. We also demonstrated that the morphological changes contributing to this remarkable improvement occur as a consequence of lignin removal from the sample. Bagasse unstructuring is favored by the loss of cohesion between neighboring cell walls, as well as by changes in the inner cell wall structure, such as damaging, hole formation and loss of mechanical resistance, facilitating liquid and enzyme access to crystalline cellulose.ConclusionsThe results presented herewith show the efficiency of the proposed method for improving the enzymatic digestibility of sugarcane bagasse and provide understanding of the pretreatment action mechanism. Combining the different techniques applied in this work warranted thorough information about the undergoing morphological and chemical changes and was an efficient approach to understand the morphological effects resulting from sample delignification and its influence on the enhanced hydrolysis results.

Tissue factor is a cell-surface glycoprotein receptor which initiates the blood coagulation cascade after vessel injury by interacting with blood clotting factor VII/VIIa and which is implicated in various pathological processes. When bound to tissue factor, factor VII is readily converted to the active protease factor VIIa by trace amounts of factors Xa, IXa or VIIa. Human tissue factor consists of 263 residues, the first 219 of which comprise the extracellular region. We have determined the crystal structure of the extracellular region at a resolution of 2.2 A. Tissue factor consists of two immunoglobulin-like domains associated through an extensive, novel, interdomain interface region. The binding site for factor VII lies at the interface region and involves residues from domain 1 and an extended loop (binding 'finger') of domain 2. This is the first reported structure of a representative of the class 2 cytokine receptor family, which also includes interferon-alpha, interferon-gamma (refs 2, 3) and interleukin-10 (ref. 4) receptors.

Hexokinase is the first enzyme in the glycolytic pathway, catalyzing the transfer of a phosphoryl group from ATP to glucose to form glucose 6-phosphate and ADP. Two yeast hexokinase isozymes are known, namely PI and PII. The crystal structure of yeast hexokinase PII from Saccharomyces cerevisiae without substrate or competitive inhibitor is determined and refined in a tetragonal crystal form at 2.2-Å resolution. The folding of the peptide chain is very similar to that of Schistosoma mansoni and previous yeast hexokinase models despite only 30% sequence identity between them. Distinct differences in conformation are found that account for the absence of glucose in the binding site. Comparison of the current model with S. mansoni and yeast hexokinase PI structures both complexed with glucose shows in atomic detail the rigid body domain closure and specific loop movements as glucose binds. A hydrophobic channel formed by strictly conserved hydrophobic residues in the small domain of the hexokinase is identified. The channel's mouth is close to the active site and passes through the small domain to its surface. The possible role of the observed channel in proton transfer is discussed.

Steered molecular dynamics simulations of ligand dissociation from Thyroid hormone receptors indicate that dissociation is favored via rearrangements in a mobile part of the LBD comprising H3, the loop between H1 and H2, and nearby beta-sheets, contrary to current models in which the H12 is mostly involved. Dissociation is facilitated in this path by the interaction of the hydrophilic part of the ligand with external water molecules, suggesting strategies to enhance ligand binding affinity.

Interleukin-22 (IL-10-related T cell-derived inducible factor/IL-TIF/IL-22) is a novel cytokine belonging to the IL-10 family. Recombinant human IL-22 (hIL-22) was found to activate the signal transducers and activators of transcription factors 1 and 3 as well as acute phase reactants in several hepatoma cell lines, suggesting its involvement in the inflammatory response. The crystallographic structure of recombinant hIL-22 has been solved at 2.0 A resolution using the SIRAS method. Contrary to IL-10, the hIL-22 dimer does not present an interpenetration of the secondary-structure elements belonging to the two distinct polypeptide chains but results from interface interactions between monomers. Structural differences between these two cytokines, revealed by the crystallographic studies, clearly indicate that, while a homodimer of IL-10 is required for signaling, hIL-22 most probably interacts with its receptor as a monomer.