Epoxy resins can be prepared from numerous chemical compositions. Until recently, alternatives to epoxy resins based on diglycidyl ethers of bisphenol A (DGEBA) or bisphenol F (DGEBF) monomers have not received commercial interest, but are presently doing so, as epoxy resins with various properties are desired. Epoxy resin systems are known to cause allergic contact dermatitis because of contents of uncured monomers, reactive diluents, and hardeners. Reactive diluents, for example, glycidyl ethers, which also contain epoxide moieties, are added to reduce viscosity and improve polymerization. We have investigated the contact allergenic properties of a series of six analogues to phenyl glycidyl ether (PGE), all with similar basic structures but with varying carbon chain lengths and degrees of saturation. The chemical reactivity of the compounds in the test series toward the hexapeptide H-Pro-His-Cys-Lys-Arg-Met-OH was investigated. All epoxides were shown to bind covalently to both cysteine and proline residues. The percent depletion of nonreacted peptide was also studied resulting in 88% depletion when using PGE and 46% when using butyl glycidyl ether (5) at the same time point, thus revealing a large difference between the fastest and the slowest reacting epoxide. The skin sensitization potencies of the epoxides using the murine local lymph node assay (LLNA) were evaluated in relation to the observed physicochemical and reactivity properties. To enable determination of statistical significance between structurally closely related compounds, a nonpooled LLNA was performed. It was found that the compounds investigated ranged from strong to weak sensitizers, congruent with the reactivity data, indicating that even small changes in chemical structure result in significant differences in sensitizing capacity.

Epoxy resin monomers, including diglycidyl ethers of bisphenol A and F (DGEBA and DGEBF), are extensively used as building blocks for thermosetting polymers. However, they are known to cause widespread contact allergy. This research describes a number of alternative epoxy resin monomers, designed with the aim of reducing the skin sensitizing potency whilst maintaining the ability to form thermosetting polymers. The compounds were designed, synthesized, assessed for skin sensitizing potency using the in vivo murine local lymph node assay, and tested for technical applicability using thermogravimetric analysis and differential scanning calorimetry. All the novel epoxy resin monomers had decreased skin sensitization potencies compared to DGEBA and DGEBF. With respect to EC3 values, which is the estimated concentration of a substance required to induce a 3-fold increase in sensitization compared to a control, the best of the new monomers had a value approximately 2.5 times higher than those of DGEBA and DGEBF. The diepoxides were reacted with triethylenetetramine and four out of the six novel monomers gave polymers with a thermal stability comparable to that obtained with DGEBA and DGEBF. The new epoxy resin monomers have the potential to replace DGEBA and DGEBF, leading to a decreased incidence of contact allergy due to epoxy resins, decreased healthcare costs, and an increased quality of life for those handling thermosetting materials.

Cinnamyl alcohol readily autoxidizes upon air exposure, and forms strong sensitizers as determined by the LLNA. Cinnamal was formed in the largest amounts, showing that cinnamal is not only formed via bioactivation, as has previously been shown. A highly sensitizing epoxide was also identified and quantified in the oxidation mixture.

Epoxy resins are among the most common causes of occupational contact dermatitis. They are normally used in so-called epoxy resin systems (ERS). These commercial products are combinations of epoxy resins, curing agents, modifiers, and reactive diluents. The most frequently used resins are diglycidyl ethers based on bisphenol A (DGEBA) and bisphenol F (DGEBF). In this study, we have investigated the contact allergenic properties of a series of analogues to the reactive diluent phenyl glycidyl ether (PGE), all with similar basic structures but with varying heteroatoms or with no heteroatom present. The chemical reactivity of the compounds in the test series toward the hexapeptide H-Pro-His-Cys-Lys-Arg-Met-OH was investigated. All epoxides were shown to bind covalently to both cysteine and proline residues. The percent depletion of nonreacted peptide was also studied resulting in ca. 60% depletion when using either PGE, phenyl 2,3-epoxypropyl sulfide (2), or N-(2,3-epoxypropyl)aniline (3), and only 15% when using 1,2-epoxy-4-phenylbutane (4) at the same time point. The skin sensitization potencies of the epoxides using the murine local lymph node assay (LLNA) were evaluated in relation to the observed physicochemical and reactivity properties. To enable determination of statistical significance between structurally closely related compounds, a nonpooled LLNA was performed. It was found that all investigated compounds containing a heteroatom in the α-position to the epoxide were strong sensitizers, congruent with the reactivity data, indicating that the impact of a heteroatom is crucial for the sensitizing capacity for this type of epoxides.

Optimized synthetic strategies for the preparation of photoswitchable molecular scaffolds based on stilbene or on thioaurone chromophores and their conformationally directing properties, as studied by computations and by NMR spectroscopy, are addressed. For the stilbene peptidomimetics 1, 2 and 3, the length of connecting linkers between the chromophore and the peptide strands was varied, resulting in photochromic dipeptidomimetics with various flexibility. Building blocks of higher rigidity, based on para-substituted thioaurone (4 and 6) and meta-substituted thioaurone chromophores (5 and 7) are shown to have a stronger conformationally directing effect. Design, synthesis, theoretical and experimental conformational analyses are presented.

Because of regulatory constraints and ethical considerations, research on alternatives to animal testing to predict the skin sensitization potential of novel chemicals has become a high priority. Ideally, these alternatives should not only predict the hazard of novel chemicals but also rate the potency of skin sensitizers. Currently, no alternative method gives reliable potency estimations for a wide range of chemicals in differing structural classes. Performing potency estimations within specific structural classes has thus been proposed. Detailed structure-activity studies for the in vivo sensitization capacity of a series of analogues of phenyl glycidyl ether (PGE) were recently published. These studies are part of an investigation regarding the allergenic activity of epoxy-resin monomers. Here we report data on the same chemicals in the KeratinoSens in vitro assay, which is based on a stable transgenic keratinocyte cell line with a luciferase gene under the control of an antioxidant response element. A strong correlation between the EC3 values in the local lymph node assay (LLNA) and both the luciferase-inducing concentrations and the cytotoxicity in the cell-based assay was established for six analogues of PGE. This correlation allowed the potency in the LLNA of two novel structurally closely related derivatives to be predicted by read-across with errors of 1.4- and 2.6-fold. However, the LLNA EC3 values of two structurally different bifunctional monomers were overpredicted on the basis of this data set, indicating that accurate potency estimation by read-across based on in vitro data might be restricted to a relatively narrow applicability domain.

Cinnamic alcohol is a frequent contact allergen, causing allergic contact dermatitis (ACD) in a substantial number of individuals sensitized from contacts with fragrances. Hence, cinnamic alcohol is one of the constituents in fragrance mix I (FM I) used for screening contact allergy in dermatitis patients. Cinnamic alcohol lacks structural alerts for protein reactivity and must therefore be activated by either air oxidation or bioactivation to be able to act as a sensitizer. In the present study, we explored the bioactivation of cinnamic alcohol using human liver microsomes (HLM), and the potential pathways for these reactions were modeled by in silico (DFT) techniques. Subsequently, the reactivity of cinnamic alcohol and its metabolites toward a model hexapeptide were investigated. In addition to cinnamic aldehyde and cinnamic acid, two highly sensitizing epoxides previously unobserved in studies of bioactivation were detected in the incubations with HLMs. Formation of epoxy cinnamic aldehyde was shown (both by the liver microsomal experiments, in which no depletion of epoxy cinnamic alcohol was observed after initial formation, and by the very high activation energy found for the oxidation thereof by calculations) to proceed via cinnamic aldehyde and not epoxy cinnamic alcohol.

Epoxy resin monomers (ERMs) are used as building blocks for thermosetting polymers in applications where strong, flexible, and lightweight materials are required. Most epoxy resins are polymers of diglycidyl ether of bisphenol A (DGEBA). It is highly allergenic and causes occupational allergic contact dermatitis and contact allergy in the general population. Thus, measures to prevent exposure by protective clothing and education are not enough. This work describes a continuation of our research aiming at reducing the skin-sensitizing potency of ERMs while maintaining the ability to form polymers. Alternative ERMs were designed and synthesized whereafter the sensitizing potency was determined using the murine local lymph node assay (LLNA). The reactivity of the diepoxides toward a nucleophilic peptide was investigated, and the differences in reactivity explained using computational studies. The diepoxides were reacted with triethylenetetramine, and the formed polymers were tested for technical applicability using thermogravimetric analysis. We had previously shown that the absence of an oxygen atom in the side chains or removal of aromaticity reduced the sensitizing potency compared to that of DGEBA. Thus, a cycloaliphatic analogue 1 of DGEBA without ether oxygen in the side chains was considered promising and was synthesized. As predicted, the sensitizing potency was considerably reduced (10 times) compared to that of DGEBA. However, the technical properties of the polymer of this compound were not considered sufficient. More polar aromatic analogues were investigated, but they could not compete with our previously described ERMs regarding polymerization properties and with 1 regarding low skin sensitization properties. Development of alternative epoxy materials is a delicate balance between allergenic activity and polymerization properties. Tuning of structural properties together with investigation of polymerization conditions combined with skin sensitization studies should be used in industrial research and development. ERM 1 could be used as a lead compound for further studies of aliphatic ERMs.