Roll-to-roll (R2R) printing has been pursued as a commercially viable high-throughput technology to manufacture flexible, disposable, and inexpensive printed electronic devices. However, in recent years, pessimism has prevailed because of the barriers faced when attempting to fabricate and integrate thin film transistors (TFTs) using an R2R printing method. In this paper, we report 20 × 20 active matrices (AMs) based on single-walled carbon nanotubes (SWCNTs) with a resolution of 9.3 points per inch (ppi) resolution, obtained using a fully R2R gravure printing process. By using SWCNTs as the semiconducting layer and poly(ethylene terephthalate) (PET) as the substrate, we have obtained a device yield above 98%, and extracted the key scalability factors required for a feasible R2R gravure manufacturing process. Multi-touch sensor arrays were achieved by laminating a pressure sensitive rubber onto the SWCNT-TFT AM. This R2R gravure printing system overcomes the barriers associated with the registration accuracy of printing each layer and the variation of the threshold voltage (Vth). By overcoming these barriers, the R2R gravure printing method can be viable as an advanced manufacturing technology, thus enabling the high-throughput production of flexible, disposable, and human-interactive cutting-edge electronic devices based on SWCNT-TFT AMs.

To demonstrate that roll-to-roll (R2R) gravure printing is a suitable advanced manufacturing method for flexible thin film transistor (TFT)-based electronic circuits, three different nanomaterial-based inks (silver nanoparticles, BaTiO3 nanoparticles and single-walled carbon nanotubes (SWNTs)) were selected and optimized to enable the realization of fully printed SWNT-based TFTs (SWNT-TFTs) on 150-m-long rolls of 0.25-m-wide poly(ethylene terephthalate) (PET). SWNT-TFTs with 5 different channel lengths, namely, 30, 80, 130, 180, and 230 μm, were fabricated using a printing speed of 8 m/min. These SWNT-TFTs were characterized, and the obtained electrical parameters were related to major mechanical factors such as web tension, registration accuracy, impression roll pressure and printing speed to determine whether these mechanical factors were the sources of the observed device-to-device variations. By utilizing the electrical parameters from the SWNT-TFTs, a Monte Carlo simulation for a 1-bit adder circuit, as a reference, was conducted to demonstrate that functional circuits with reasonable complexity can indeed be manufactured using R2R gravure printing. The simulation results suggest that circuits with complexity, similar to the full adder circuit, can be printed with a 76% circuit yield if threshold voltage (Vth) variations of less than 30% can be maintained.

Roll-to-roll (R2R) gravure is considered one of the highest throughput tools for manufacturing inexpensive and flexible ubiquitous IT devices called "smart packaging" in which NFC (near-field communication) transponder, sensors, ADC (analog-to-digital converter), simple processor and signage are all integrated on paper or plastic foils. In this review, we show R2R gravure can be employed to print smart packaging, starting from printing simple electrodes, dielectrics, capacitors, diodes and thin film transistors with appropriate nanomaterial-based inks on plastic foils.

Floating gated silicon-on-insulator nonvolatile memory devices with Au nanoparticles embedded in SiO1.3N insulators were fabricated. The tunneling SiO1.3N insulator, Au nanoparticles, and control SiO1.3N insulator were sequentially deposited by digital sputtering method at 300°C. The size of Au nanoparticles was controlled in the range of 1–5nm by adjusting the deposition thickness of Au layer and the density of Au nanoparticles was approximately 1.5×1012cm−2. A significant threshold voltage shift of fabricated floating gate memory devices was obtained due to the charging effects of Au particles and the memory window was larger than 2.5V.

No abstract