No abstract

Doping of graphene with heteroatoms is an effective way to tailor its properties. Here we describe a simple and scalable method of doping graphene lattice with sulfur atoms during the thermal exfoliation process of graphite oxides. The graphite oxides were first prepared by Staudenmaier, Hofmann, and Hummers methods followed by treatments in hydrogen sulfide, sulfur dioxide, or carbon disulfide. The doped materials were characterized by scanning electron microscopy, high-resolution X-ray photoelectron spectroscopy, combustible elemental analysis, and Raman spectroscopy. The ζ-potential and conductivity of sulfur-doped graphenes were also investigated in this paper. It was found that the level of doping is more dramatically influenced by the type of graphite oxide used rather than the type of sulfur-containing gas used during exfoliation. Resulting sulfur-doped graphenes act as metal-free electrocatalysts for an oxygen reduction reaction.

Large-scale fabrication of graphene is highly important for industrial and academic applications of this material. The most common large-scale preparation method is the oxidation of graphite to graphite oxide using concentrated acids in the presence of strong oxidants and consequent thermal exfoliation and reduction by thermal shock to produce reduced graphene. These oxidation methods typically use concentrated sulfuric acid (a) in combination with fuming nitric acid and KClO(3) (Staudenmaier method), (b) in combination with concentrated nitric acid and KClO(3) (Hofmann method) or (c) in the absence of nitric acid but in the presence of NaNO(3) and KMnO(4) (Hummers method). The evaluation of quality and applicability of the graphenes produced by these various methods is of high importance and is attempted side-by-side for the first time in this paper. Full-scale characterization of thermally reduced graphenes prepared by these standard methods was performed with techniques such as transmission and scanning electron microscopy, Raman spectroscopy and X-ray photoelectron spectroscopy. Their applicability for electrochemical devices was further evaluated by means of cyclic voltammetry techniques. We showed that while Staudenmaier and Hofmann methods (methods that do not use potassium permanganate as oxidant) generated thermally reduced graphenes with comparable electrochemical properties, the graphene prepared by the Hummers method which uses permanganate as oxidant showed higher heterogeneous electron transfer rates and lower overpotentials as compared to graphenes prepared by the Staudenmaier or Hofmann methods. This clearly shows that the methods of preparations have dramatic influences on the materials properties and, thus, such findings are of eminent importance for practical applications as well as for academic research.

Vitamin K(1) (VK(1)) was shown by voltammetry and coulometry to undergo two chemically reversible one-electron reduction processes in acetonitrile (CH(3)CN) containing 0.2 M Bu(4)NPF(6) as the supporting electrolyte. The potential separation between the first and second electron-transfer steps diminished sequentially with the addition of water, so that at a H(2)O concentration of approximately 7 M (approximately 13% v/v) only one process was detected, corresponding to the reversible transfer of two electrons per molecule. The voltammetric behavior was interpreted on the basis of the degree of hydrogen bonding between the reduced forms of VK(1) with water in the solvent. It was found that the potential separation between the first and second processes was especially sensitive to water in the low molar levels (0.001-0.1 M); therefore, by measuring the peak separation as a function of controlled water concentrations (accurately determined by Karl Fischer coulometric titrations) it was possible to prepare calibration curves of peak separation versus water concentration. The calibration procedure is independent of the type of reference electrode and can be used to determine the water content of CH(3)CN between 0.01 and 5 M, by performing a single voltammetric scan in the presence of 1.0 mM VK(1). The voltammetry was also investigated in dichloromethane, dimethylformamide, and dimethyl sulfoxide. The reduction processes were monitored by in situ electrochemical UV-vis spectroscopy in CH(3)CN over a range of water concentrations (0.05-10 M) to spectroscopically identify the hydrogen-bonded species.

Fully hydrogenated graphene (graphane) and partially hydrogenated graphene materials are expected to possess various fundamentally different properties from graphene. We have prepared highly hydrogenated graphene containing 5% wt of hydrogen via Birch reduction of graphite oxide using elemental sodium in liquid NH3 as electron donor and methanol as proton donor in the reduction. We also investigate the influence of preparation method of graphite oxide, such as the Staudenmaier, Hofmann or Hummers methods on the hydrogenation rate. A control experiment involving NaNH2 instead of elemental Na was also performed. The materials were characterized in detail by electron microscopy, infrared spectroscopy, X-ray photoelectron spectroscopy, Raman spectroscopy both at room and low temperatures, X-ray fluorescence spectroscopy, inductively coupled plasma optical emission spectroscopy, combustible elemental analysis and electrical resistivity measurements. Magnetic measurements are provided of bulk quantities of highly hydrogenated graphene. In the whole temperature range up to room temperature, the hydrogenated graphene exhibits a weak ferromagnetism in addition to a contribution proportional to field that is caused not only by diamagnetism but also likely by an antiferromagnetic influence. The origin of the magnetism is also determined to arise from the hydrogenated graphene itself, and not as a result of any metallic impurities.

Nanoarchitectonics on graphene implicates a specific and exact anchoring of molecules or nanoparticles onto the surface of graphene. One such example of an effective anchoring group that is highly reactive is the halogen moiety. Herein we describe a simple and scalable method for the introduction of halogen (chlorine, bromine, and iodine) moieties onto the surface of graphene by thermal exfoliation/reduction of graphite oxide in the corresponding gaseous halogen atmosphere. We characterized the halogenated graphene by using various techniques, including scanning and transmission electron microscopy, Raman spectroscopy, high-resolution X-ray photoelectron spectroscopy, and electrochemistry. The halogen atoms that have successfully been attached to the graphene surfaces will serve as basic building blocks for further graphene nanoarchitectonics.

Metal decorated graphene materials are highly important for catalysis. In this work, noble metal doped-graphene hybrids were prepared by a simple and scalable method. The thermal reductions of metal doped-graphite oxide precursors were carried out in nitrogen and hydrogen atmospheres and the effects of these atmospheres as well as the metal components on the characteristics and catalytic capabilities of the hybrid materials were studied. The hybrids exfoliated in nitrogen atmosphere contained a higher amount of oxygen-containing groups and lower density of defects on their surfaces than hybrids exfoliated in hydrogen atmosphere. The metals significantly affected the electrochemical behavior and catalysis of compounds that are important in energy production and storage and in electrochemical sensing. Research in the field of energy storage and production, electrochemical sensing and biosensing as well as biomedical devices can take advantage of the properties and catalytic capabilities of the metal doped graphene hybrids.

The conversion of graphene to graphane is of high importance from a technological and scientific point of view. We present here a scalable method for the hydrogenation of graphene based on thermal exfoliation of graphite oxide in a hydrogen atmosphere under high pressure (60-150 bar) and temperature (200-500 °C). This method does not require a plasma source and is able to produce gram quantities of the material. The properties of the resultant hydrogenated graphene were studied by scanning and transmission electron microscopy, Raman spectroscopy, X-ray photoelectron spectroscopy, infrared spectroscopy and combustible elemental analysis techniques. Sheet and specific resistance of the graphene and hydrogenated graphene were measured. This scalable synthesis method has great potential to serve as a pathway towards the mass production of graphane.