No abstract

Mycobacterium bovis is the main cause of bovine tuberculosis (BTB) in cattle and can also infect humans. Zebu cattle are considered more resistant to some infectious diseases compared with Holstein-Friesian (HF) cattle, including BTB. However, epidemiological studies may not take into account usage differences of the two types of cattle. HF cattle may suffer greater metabolic stress due to their more or less How to cite this article: Alcaraz-López OA, Flores-Villalva S, Cortéz-Hernández O, et al. Association of immune responses of Zebu and Holstein-Friesian cattle and resistance to mycobacteria in a BCG challenge model.

To take advantage of the residues generated in the production of products from green coffee and due to the special interest in the compounds contained in the bean, a by-product obtained after the extraction of the oil was studied. The physical characterization of the green-coffee-bean by-product was carried out. Subsequently, the extraction of compound 5-CQA was carried out via leaching using central composition design 24 and evaluating factors such as temperature, time, solid/solvent ratio, and ethanol percentage, and its yield was quantified using HPLC. In addition, the response-surface methodology was used to maximize the efficiency of 5-CQA extraction and to perform the kinetic study. Yields of 59 ± 2 mg of 5-CQA/g from the by-product were obtained, and by selecting the best leaching conditions, the kinetic study was performed at 45, 60, and 75 °C, increasing the yield to a total of 61.8 ± 3 mg of 5-CQA/g. By applying the kinetic model of mass transfer, a fit of R2 > 0.97 was obtained, with KLa values between 0.266 and 0.320 min−1. This study showed an approach to optimize the 5-CQA extraction conditions, resulting in a simple, fast, reproducible, accurate, and low-cost method.

In the search for oils of commercial interest that serve as new sources for the generation of cosmetic, pharmaceutical, or nutraceutical products, the green coffee beans oil (Coffea arabica L.) was studied. This research aimed to evaluate the oxidative stability of microencapsulated green coffee oil (Coffea arabica) by spray drying. The green coffee oil emulsions were produced by microfluidization using mesquite gum and octenyl succinic anhydride modified starches (OSA-starch) as wall-material. The particle size, polydispersity, and zeta potential on the microfluidized emulsions were optimized. The results showed that microfluidization had positive effects on the reduction of the emulsion droplets and the zeta potential, developing stable emulsions for both polymers. Then, the optimal microfluidization conditions were used to evaluate the impact of the spray drying conditions on the microencapsulation efficiency, morphology, and oxidation stability of the green coffee oil microcapsules under accelerated storage conditions (32% relative humidity (RH) at 25 °C). The microencapsulation efficiency was approximately 98% for both wall-materials. The morphology of the microcapsules showed spherical shapes and polydisperse sizes, a typical characteristic of spray-dried powders. The oxidative stability of the microcapsules was lower than the bulk green coffee oil (87.39 meq of O2/kg of oil), reaching values of 60.83 meq of O2/kg of oil for mesquite gum and 70.67 meq of O2/kg of oil for OSA-starch. The microcapsules produced have good potential for the development of nutraceutical foods or cosmetic formulations with adequate stability.