The efficient use of natural gas will require catalysts that can activate the first C-H bond of methane while suppressing complete dehydrogenation and avoiding overoxidation. We report that single iron sites embedded in a silica matrix enable direct, nonoxidative conversion of methane, exclusively to ethylene and aromatics. The reaction is initiated by catalytic generation of methyl radicals, followed by a series of gas-phase reactions. The absence of adjacent iron sites prevents catalytic C-C coupling, further oligomerization, and hence, coke deposition. At 1363 kelvin, methane conversion reached a maximum at 48.1% and ethylene selectivity peaked at 48.4%, whereas the total hydrocarbon selectivity exceeded 99%, representing an atom-economical transformation process of methane. The lattice-confined single iron sites delivered stable performance, with no deactivation observed during a 60-hour test.

ABSTRACT:We have investigated the photocatalysis of partially deuterated methanol (CD 3 OH) and H 2 O on TiO 2 (110) at 400 nm using a newly developed photocatalysis apparatus in combination with theoretical calculations. Photocatalyzed products, CD 2 O on Ti 5c sites, and H and D atoms on bridge-bonded oxygen (BBO) sites from CD 3 OH have been clearly detected, while no evidence of H 2 O photocatalysis was found. The experimental results show that dissociation of CD 3 OH on TiO 2 (110) occurs in a stepwise manner in which the O−H dissociation proceeds first and is then followed by C−D dissociation. Theoretical calculations indicate that the high reverse barrier to C−D recombination and the facile desorption of CD 2 O make photocatalytic methanol dissociation on TiO 2 (110) proceed efficiently. Theoretical results also reveal that the reverse reactions, i.e, O−H recombination after H 2 O photocatalytic dissociation on TiO 2 (110), may occur easily, thus inhibiting efficient photocatalytic water splitting. ■ INTRODUCTIONTitanium dioxide has been extensively investigated as a catalyst or photocatalyst, 1−11 particularly in applications involving photodegradation of organic molecules and water splitting, 5,12,13 which have important implications in environmental remediation and clean energy. Pure TiO 2 is apparently not photocatalytically active for splitting water to produce hydrogen, 14 but the addition of methanol to water can dramatically enhance the photocatalytic activity for hydrogen production. 15 Therefore, understanding the key differences between the photocatalytic chemistry of methanol and water on a model TiO 2 surface at the molecular level may provide valuable insight into the dynamics of photocatalysis that would enhance efforts for developing new and efficient photocatalysts for water splitting.Theoretical and experimental studies often focus on TiO 2 (110) as a model surface, 6,16 with the methanol/ TiO 2 (110) system serving as a model for photocatalysis on TiO 2 . 17−20 Henderson and co-workers 18 conducted a temperature-programmed desorption (TPD) study of CH 3 OH on TiO 2 (110) and concluded that the majority of the CH 3 OH molecules are adsorbed in molecular form. This conclusion is consistent with a scanning tunneling microscopy study by Dohnalek et al. 10 that showed that methanol molecules are adsorbed molecularly on the Ti 5c sites and are dissociated only at bridge-bonded oxygen (BBO) vacancy sites. The photocatalysis of CH 3 OH on TiO 2 (110) was investigated in a twophoton photoemission (2PPE) experiment, which inferred the presence of an excited electronic state on the surface. 20,21 Zhou et al. attributed this surface state to a photocatalytic dissociated state of methanol using a time-dependent 2PPE (TD-2PPE) technique. 22 They also used a combination of photoexcitation with STM and found that 400 nm light could induce dissociation of methanol on the surface, and they assigned the dissociated state as methoxy (CH 3 O) on a Ti 5c site and a hydrogen atom on a BBO site. Shen and Hend...

Clean hydrogen production is highly desirable for future energy needs, making the understanding of molecular-level phenomena underlying photocatalytic hydrogen production both fundamentally and practically important. Water splitting on pure TiO 2 is inefficient, however, adding sacrificial methanol could significantly enhance the photocatalyzed H 2 production. Therefore, understanding the photochemistry of methanol on TiO 2 at the molecular level could provide important insights to its photocatalytic activity. Here, we report the first clear evidence of photocatalyzed splitting of methanol on TiO 2 derived from time-dependent two-photon photoemission (TD-2PPE) results in combination with scanning tunneling microscopy (STM). STM tip induced molecular manipulation before and after UV light irradiation clearly reveals photocatalytic bond cleavage, which occurs only at Ti 4+ surface sites. TD-2PPE reveals that the kinetics of methanol photodissociation is clearly not of single exponential, an important characteristic of this intrinsically heterogeneous photoreaction.

Photocatalytic hydrogen production and pollutant degradation provided both great opportunities and challenges in the field of sustainable energy and environmental science. Over the past few decades, we have witnessed fast growing interest and efforts in developing new photocatalysts, improving catalytic efficiency and exploring the reaction mechanism at the atomic and molecular levels. Owing to its relatively high efficiency, nontoxicity, low cost and high stability, TiO2 becomes one of the most extensively investigated metal oxides in semiconductor photocatalysis. Fundamental studies on well characterized single crystals using ultrahigh vacuum based surface science techniques could provide key microscopic insight into the underlying mechanism of photocatalysis. In this review, we have summarized recent progress in the photocatalytic chemistry of hydrogen, water, oxygen, carbon monoxide, alcohols, aldehydes, ketones and carboxylic acids on TiO2 surfaces. We focused this review mainly on the rutile TiO2(110) surface, but some results on the rutile TiO2(011), anatase TiO2(101) and (001) surfaces are also discussed. These studies provided fundamental insights into surface photocatalysis as well as stimulated new investigations in this exciting field. At the end of this review, we have discussed how these studies can help us to develop new photocatalysis models.

The transient titanium alkylidyne complex (PNP)TiCtBu (PNP = N-[2-P(CHMe2)2-4-methylphenyl]2-), prepared from alpha-hydrogen abstraction of the corresponding alkylidene-alkyl species (PNP)Ti=CHtBu(CH2tBu), can readily undergo intermolecular 1,2-addition of C-H bonds of benzene and SiMe4. Synthesis and reactivity, isotopic labeling, kinetics, and theoretical studies strongly favor an alkylidyne pathway and the alpha-H abstraction step to be the rate-determining step.

Alpha-hydrogen abstraction and alpha-hydrogen migration reactions yield novel titanium(IV) complexes bearing terminal phosphinidene ligands. Via an alpha-H migration reaction, the phosphinidene ((tBu)nacnac)Ti=P[Trip](CH(2)(tBu) ((tBu)nacnac(-) = [Ar]NC((t)Bu)CHC((t)Bu)N[Ar], Ar = 2,6-(CHMe2)(2C6H3, Trip = 2,4,6-(i)Pr3C6H2) was prepared by the addition of the primary phosphide LiPH[Trip] to the nucleophilic alkylidene triflato complex ((tBu)nacnac)Ti=CH(t)Bu(OTf), while alpha-H abstraction was promoted by the addition of LiPH[Trip] to the dimethyl triflato precursor ((tBu)nacnac)Ti(CH)(2)(OTf) to afford ((tBu)nacnac)Ti=P[Trip](CH3). Treatment of ((tBu)nacnac)Ti=P[Trip](CH3) with B(C6F5)(3) induces methide abstraction concurrent with formation of the first titanium(IV) phosphinidene zwitterion complex ((tBu)nacnac)Ti=P[Trip]{CH3B(C6F5)(3)}. Complex ((tBu)nacnac)Ti=P[Trip]{CH3B(C6F5)(3)} [2 + 2] cycloadds readily PhCCPh to afford the phosphametallacyclobutene [((tBu)nacnac)Ti(P[Trip]PhCCPh)][CH3B(C6F5)(3)]. These titanium(IV) phosphinidene complexes possess the shortest Ti=P bonds reported, have linear phosphinidene groups, and reveal significantly upfielded solution 31P NMR spectroscopic resonances for the phosphinidene phosphorus. Solid state 31P NMR spectroscopic data also corroborate with all three complexes possessing considerably shielded chemical shifts for the linear and terminal phosphinidene functionality. In addition, high-level DFT studies on the phosphinidenes suggest the terminal phosphinidene linkage to be stabilized via a pseudo Ti[triple bond]P bond. Linearity about the Ti-P-C(ipso) linkage is highly dependent on the sterically encumbering substituents protecting the phosphinidene. Complex ((tBu)nacnac)Ti=P[Trip]{CH3B(C6F5))(3)} can catalyze the hydrophosphination of PhCCPh with H(2)PPh to produce the secondary vinylphosphine HP[Ph]PhC=CHPh. In addition, we demonstrate that this zwitterion is a powerful phospha-Staudinger reagent and can therefore act as a carboamination precatalyst of diphenylacetylene with aldimines.

Unmasking the truth: The dimer [{(μ2‐PNP)Co}2] (Co light blue, N dark blue, P green, C gray, only one carbon atom of the isopropyl groups shown; PNP=[N{2‐P(CHMe2)2‐4‐MeC6H3}2]−) contains a Co2N2 diamond core and bridging PNP ligands. Upon reaction with ClCPh3, CO, or N2, rearrangement of the PNP ligands to a terminal chelating mode is observed to give four‐coordinate Co complexes such as [{(PNP)Co}2(μ2‐N2)].

The neopentylidene-neopentyl complex (PNP)Ti=CH(t)Bu(CH2(t)Bu) (2; PNP(-) = N[2-P(CHMe2)(2-)4-methylphenyl]2), prepared from the precursor (PNP)Ti[triple bond]CH(t)Bu(OTf) (1) and LiCH2(t)Bu, extrudes neopentane in neat benzene under mild conditions (25 degrees C) to generate the transient titanium alkylidyne, (PNP)Ti[triple bond]C(t)Bu (A), which subsequently undergoes 1,2-CH bond addition of benzene across the Ti[triple bond]C linkage to generate (PNP)Ti=CH(t)Bu(C6H5) (3). Kinetic, mechanistic, and theoretical studies suggest the C-H activation process to obey pseudo-first-order in titanium, the alpha-hydrogen abstraction to be the rate-determining step (KIE for 2/2-d(3) conversion to 3/3-d(3) = 3.9(5) at 40 degrees C) with activation parameters DeltaH = 24(7) kcal/mol and DeltaS = -2(3) cal/mol.K, and the post-rate-determining step to be C-H bond activation of benzene (primary KIE = 1.03(7) at 25 degrees C for the intermolecular C-H activation reaction in C6H6 vs C6D6). A KIE of 1.33(3) at 25 degrees C arose when the intramolecular C-H activation reaction was monitored with 1,3,5-C6H3D3. For the activation of aromatic C-H bonds, however, the formation of the sigma-complex becomes rate-determining via a hypothetical intermediate (PNP)Ti[triple bond]C(t)Bu(C6H5), and C-H bond rupture is promoted in a heterolytic fashion by applying standard Lewis acid/base chemistry. Thermolysis of 3 in C6D6 at 95 degrees C over 48 h generates 3-d(6), thereby implying that 3 can slowly equilibrate with A under elevated temperatures with k = 1.2(2) x 10-5 s(-1), and with activation parameters DeltaH = 31(16) kcal/mol and DeltaS = 3(9) cal/mol x K. At 95 degrees C for one week, the EIE for the 2 --> 3 reaction in 1,3,5-C6H3D3 was found to be 1.36(7). When 1 is alkylated with LiCH2SiMe3 and KCH2Ph, the complexes (PNP)Ti=CHtBu(CH2SiMe3) (4) and (PNP)Ti=CHtBu(CH2Ph) (6) are formed, respectively, along with their corresponding tautomers (PNP)Ti=CHSiMe3(CH2tBu) (5) and (PNP)Ti=CHPh(CH2tBu) (7). By means of similar alkylations of (PNP)Ti=CHSiMe3(OTf) (8), the degenerate complex (PNP)Ti=CHSiMe3(CH2SiMe3) (9) or the non-degenerate alkylidene-alkyl complex (PNP)Ti=CHPh(CH2SiMe3) (11) can also be obtained, the latter of which results from a tautomerization process. Compounds 4/5 and 9, or 6/7 and 11, also activate benzene to afford (PNP)Ti=CHR(C6H5) (R = SiMe3 (10), Ph (12)). Substrates such as FC6H5, 1,2-F2C6H4, and 1,4-F2C6H4 react at the aryl C-H bond with intermediate A, in some cases regioselectively, to form the neopentylidene-aryl derivatives (PNP)Ti=CHtBu(aryl). Intermediate A can also perform stepwise alkylidene-alkyl metatheses with 1,3,5-Me3C6H3, SiMe4, 1,2-bis(trimethylsilyl)alkyne, and bis(trimethylsilyl)ether to afford the titanium alkylidene-alkyls (PNP)Ti=CHR(R') (R = 3,5-Me2C6H2, R' = CH2-3,5-Me2C6H2; R = SiMe3, R' = CH2SiMe3; R = SiMe2CCSiMe3, R' = CH2SiMe2CCSiMe3; R = SiMe2OSiMe3, R' = CH2SiMe2OSiMe3).