No abstract

A new electrochemical method to detect and quantify the explosive compound 2,4,6-trinitrotoluene (TNT) in aqueous solutions is demonstrated. A disposable thin-film electrode modified with a droplet of a gel-polymer electrolyte (GPE) was immersed directly into samples of TNT at concentrations of 1-10 μg/mL. The GPE contained the hydrophobic room-temperature ionic liquid (RTIL) trihexyltetradecylphosphonium bis(trifluoromethylsulfonyl)imide ([P][NTf]) and the polymer poly(hexyl methacrylate). The RTIL acted to preconcentrate TNT into the GPE and provided ionic conductivity. The polymer provided both (i) sufficient viscosity to ensure mechanical stability of the GPE and (ii) strong hydrophobicity to minimize leaching of the RTIL. Square wave voltammetry was performed on the first reduction peak of TNT-preconcentrated samples (15 min soaking with mechanical stirring), with linear plots of peak current vs cumulative concentration of TNT, giving an averaged limit of detection of 0.37 μg/mL (aqueous phase concentration). Additionally, the voltammetry of the first reduction peak of TNT in [P][NTf] was unaffected by the presence of oxygen-in contrast to that observed in an imidazolium-based RTIL-providing excellent selectivity over oxygen in real environments. The sensor device was able to quickly and easily quantify TNT concentrations at typical ground water contamination levels. The low-cost and portability of the sensor device, along with the minimal amounts of GPE materials required, make this a viable platform for the onsite monitoring of explosives, which is currently a significant operational challenge.

Porous copper nanoarchitectures are obtained selectively by acid-dealloying of Mg–Cu precursors prepared by microwave-induced-metal-plasma methods; the entire process is reversible.

Explosives residues in soils may be a useful source of evidence following the detonation of an improvised explosive device (IED), such as a vehicle-borne IED. Soil samples collected from the vicinity of an explosion scene will often be stored for some time prior to analysis, yet explosives residues in soil samples are susceptible to rapid degradation or transformation. Although some research has assessed the use of different storage temperatures with a view to reducing explosives' degradation over time, further research examining the degradation of explosives in soil when stored under a variety of storage conditions is crucial to determine the optimal sample collection and storage procedures for soil containing explosives residues. In this work, three different soils were spiked with solutions of TNT, RDX and PETN and stored either at room temperature, refrigerated or frozen. Samples were extracted over 6 weeks, with additional samples gamma-irradiated or nitrogen purged prior to storage. Experimental results indicate that TNT underwent very rapid degradation at room temperature, attributed to microbial action, whereas PETN and RDX proved to be more stable. Gamma irradiation and nitrogen purging proved of some benefit for mitigating TNT degradation, with lower storage temperatures ultimately proving the most effective method of mitigating degradation.