The realization of highly flexible and all-solid-state energy-storage devices strongly depends on both the electrical properties and mechanical integrity of the constitutive materials and the controlled assembly of electrode and solid electrolyte. Herein we report the preparation of all-solid-state flexible supercapacitors (SCs) through the easy assembly of functionalized reduced graphene oxide (f-RGO) thin films (as electrode) and solvent-cast Nafion electrolyte membranes (as electrolyte and separator). In particular, the f-RGO-based SCs (f-RGO-SCs) showed a 2-fold higher specific capacitance (118.5 F/g at 1 A/g) and rate capability (90% retention at 30 A/g) compared to those of all-solid-state graphene SCs (62.3 F/g at 1A/g and 48% retention at 30 A/g). As proven by the 4-fold faster relaxation of the f-RGO-SCs than that of the RGO-SCs and more capacitive behavior of the former at the low-frequency region, these results were attributed to the facilitated ionic transport at the electrical double layer by means of the interfacial engineering of RGO by Nafion. Moreover, the superiority of all-solid-state flexible f-RGO-SCs was demonstrated by the good performance durability under the 1000 cycles of charging and discharging due to the mechanical integrity as a consequence of the interconnected networking structures. Therefore, this research provides new insight into the rational design and fabrication of all-solid-state flexible energy-storage devices as well as the fundamental understanding of ion and charge transport at the interface.

No abstract

naming of energy storage devices after their own core materials: conventional batteries such as lead-acid batteries, which are named after the lead-based active material and the acidic electrolyte; nickelcadmium batteries named after the nickeland cadmium-based active materials; nickel-metal hybrid batteries named after the nickel-and metal hydride-based active materials; state-of-the-art lithium-ion batteries (LIBs), named after the lithiated host materials and lithium-ion carriers; and next-generation batteries such as sodiumion, lithium-sulfur, and lithium-air batteries, which are named after the lithium metal anode and sulfur or O 2 cathode. [4][5][6][7][8][9] In short, whenever energy storage materials made a breakthrough, new-generation energy storage devices appeared. Among electrochemical energy storage devices, supercapacitors (SCs), which can store charges at the surface, have advantages over LIB and conventional batteries in terms of high power, fast charging/ discharging rates, and long cyclability, as will be discussed in Section 2.1. However, the low energy density of SCs remains a critical challenge for emerging applications such as next-generation electronic systems, electrical vehicles (EVs), and renewable energy storage systems (ESSs). [10,11] Based on the long history of energy storage research, new and emerging materials are expected to provide solutions to this problem.Returning to the chronological development of SCs, SCs have been revolutionized by the emergence of new materials, as Two dimensional (2D) nanomaterials are very attractive due to their unique structural and surface features for energy storage applications. Motivated by the recent pioneering works demonstrating "the emergent pseudocapacitance of 2D nanomaterials," the energy storage and nanoscience communities could revisit bulk layered materials though state-of-the-art nanotechnology such as nanostructuring, nanoarchitecturing, and compositional control. However, no review has focused on the fundamentals, recent progress, and outlook on this new mechanism of 2D nanomaterials yet. In this study, the key aspects of emergent pseudocapacitors based on 2D nanomaterials are comprehensively reviewed, which covers the history, classification, thermodynamic and kinetic aspects, electrochemical characteristics, and design guidelines of materials for extrinsically surface redox and intercalation pseudocapacitors. The structural and compositional controls of graphene and other carbon nanosheets, transition metal oxides and hydroxides, transition metal dichalcogenides, and metal carbide/nitride on both microscopic and macroscopic levels will be particularly addressed, emphasizing the important results published since 2010. Finally, perspectives on the current impediments and future directions of this field are offered. Unlimited combinations and modifications of 2D nanomaterials can provide a rational strategy to overcome intrinsic limitations of existing materials, offering a new-generation energy storage materials toward a high and new p...

We report the preparation of free-standing flexible conductive reduced graphene oxide/Nafion (RGON) hybrid films by a solution chemistry that utilizes self-assembly and directional convective-assembly. The hydrophobic backbone of Nafion provided well-defined integrated structures, on micro- and macroscales, for the construction of hybrid materials through self-assembly, while the hydrophilic sulfonate groups enabled highly stable dispersibility ( approximately 0.5 mg/mL) and long-term stability (2 months) for graphene. The geometrically interlocked morphology of RGON produced a high degree of mechanical integrity in the hybrid films, while the interpenetrating network constructed favorable conduction pathways for charge transport. Importantly, the synergistic electrochemical characteristics of RGON were attributed to high conductivity (1176 S/m), facilitated electron transfer (ET), and low interfacial resistance. Consequently, RGON films obtained the excellent figure of merit as electrochemical biosensing platforms for organophosphate (OP) detection, that is, a sensitivity of 10.7 nA/microM, detection limit of 1.37 x 10(-7) M, and response time of <3 s. In addition, the reliability of RGON biosensors was confirmed by a fatigue test of 100 bending cycles. The strategy described here provides insight into the fabrication of graphene and hybrid nanomaterials from a material perspective, as well as the design of biosensor platforms for practical device applications.

2D materials, their features and possible approaches to mitigating the challenges in Li–S batteries are discussed.

No abstract

The chemistry and structure of ion channels within the polymer electrolytes are of prime importance for studying the transport properties of electrolytes as well as for developing high-performance electrochemical devices. Despite intensive efforts on the synthesis of polymer electrolytes, few studies have demonstrated enhanced target ion conduction while suppressing unfavorable ion or mass transport because the undesirable transport occurs through an identical pathway. Herein, we report an innovative, chemical strategy for the synthesis of polymer electrolytes whose ion-conducting channels are physically and chemically modulated by the ionic (not electronic) conductive, functionalized graphenes and for a fundamental understanding of ion and mass transport occurring in nanoscale ionic clusters. The functionalized graphenes controlled the state of water by means of nanoscale manipulation of the physical geometry and chemical functionality of ionic channels. Furthermore, the confinement of bound water within the reorganized nanochannels of composite membranes was confirmed by the enhanced proton conductivity at high temperature and the low activation energy for ionic conduction through a Grotthus-type mechanism. The selectively facilitated transport behavior of composite membranes such as high proton conductivity and low methanol crossover was attributed to the confined bound water, resulting in high-performance fuel cells.

Metal–organic frameworks (MOFs) with intrinsically porous structures are promising candidates for energy storage, however, their low electrical conductivity limits their electrochemical energy storage applications. Herein, the hybrid architecture of intrinsically conductive Cu‐MOF nanowire arrays on self‐supported polypyrrole (PPy) membrane is reported for integrated flexible supercapacitor (SC) electrodes without any inactive additives, binders, or substrates involved. The conductive Cu‐MOFs nanowire arrays afford high conductivity and a sufficiently active surface area for the accessibility of electrolyte, whereas the PPy membrane provides decent mechanical flexibility, efficient charge transfer skeleton, and extra capacitance. The all‐solid‐state flexible SC using integrated hybrid electrode demonstrates an exceptional areal capacitance of 252.1 mF cm−2, an energy density of 22.4 µWh cm−2, and a power density of 1.1 mW cm−2, accompanied by an excellent cycle capability and mechanical flexibility over a wide range of working temperatures. This work not only presents a robust and flexible electrode for wide temperature range operating SC but also offers valuable concepts with regards to designing MOF‐based hybrid materials for energy storage and conversion systems.