Ceramics are often prepared with surface layers of different composition from the bulk, in order to impart a specific functionality to the surface or to act as a protective layer for the bulk material. Here we describe a general process by which functional surface layers with a nanometre-scale compositional gradient can be readily formed during the production of bulk ceramic components. The basis of our approach is to incorporate selected low-molecular-mass additives into either the precursor polymer from which the ceramic forms, or the binder polymer used to prepare bulk components from ceramic powders. Thermal treatment of the resulting bodies leads to controlled phase separation ('bleed out') of the additives, analogous to the normally undesirable outward loss of low-molecular-mass components from some plastics; subsequent calcination stabilizes the compositionally changed surface region, generating a functional surface layer. This approach is applicable to a wide range of materials and morphologies, and should find use in catalysts, composites and environmental barrier coatings.
A continuous photoreactor, working in a total recycle mode and irradiated by a low-pressure Hg lamp, has been used to study the bactericidal effect of a photocatalyst, formed by TiO 2 embedded in SiO 2 fibres, on Legionella pneumophila and a consortium of common gram-negative aerobic bacteria (Escherichia coli, Klebsiella sp., Pseudomona sp. and Proteus sp.) in water. The kinetic modeling of the inactivation process, carried out with the measured values of viable bacteria concentration at the outlet of photoreactor, evidenced that for each pass inside the photoreactor the ratio between the outlet and inlet cell concentrations was of order of 0.01 for the inactivation of L. pneumophila. For the other aerobic bacteria, which are usually taken as reference in photocatalytic bacteria inactivation studies, this ratio was of order of 0.3 for the first hour of illumination, while upon prolonged irradiation (up to 9 h) this ratio increased to 0.7. Several factors inducing this latter decrease of efficiency are possible, as e.g. competition for photocatalytic attack between microorganisms and organic compounds released by damaged bacteria or photoinduced alteration of a small fraction of still viable bacteria making them less interactive with the photocatalyst. The inactivation mechanism normally proposed for common bacteria involves an initial attack of the photogenerated radicals to the outer membrane; the consequent membrane dispersion allows the radicals to damage the cytoplasmic membrane. The higher lethality of the photocatalytic method observed towards Legionella (in comparison to the other aerobic bacteria) is explained considering that the radicals attack the Legionella secretion system, which is adapted for high virulence and would become activated for and through adhesion to the TiO 2 surface. This attack would then be able to inactivate L. pneumophila without dispersing the outer membrane. Apart from this, the water flow through the catalyst fibres can facilitate the bacteria transport towards the anatase surface, and additionally the generated shear stress may help adhesion, at least for some bacteria as E. coli, contributing further to improve the photokilling efficiency; both factors may contribute to the efficiency of this photoreactor configuration.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.