No abstract

No abstract

In posterior stabilised total knee replacement (TKR) a larger femoral component is sometimes selected to manage the increased flexion gap caused by resection of the posterior cruciate ligament. However, concerns remain regarding the adverse effect of the increased anteroposterior dimensions of the femoral component on the patellofemoral (PF) joint. Meanwhile, the gender-specific femoral component has a narrower and thinner anterior flange and is expected to reduce the PF contact force. PF contact forces were measured at 90°, 120°, 130° and 140° of flexion using the NexGen Legacy Posterior Stabilized (LPS)-Flex Fixed Bearing Knee system using Standard, Upsized and Gender femoral components during TKR. Increasing the size of the femoral component significantly increased mean PF forces at 120°, 130° and 140° of flexion (p = 0.005, p < 0.001 and p < 0.001, respectively). No difference was found in contact force between the Gender and the Standard components. Among the patients who had overhang of the Standard component, mean contact forces with the Gender component were slightly lower than those of the Standard component, but no statistical difference was found at 90°, 120°, 130° or 140° of flexion (p = 0.689, 0.615, 0.253 and 0.248, respectively). Upsized femoral components would increase PF forces in deep knee flexion. Gender-specific implants would not reduce PF forces.

No abstract

No abstract

A disadvantage to using extramedullary alignment guides of the tibia for total knee arthroplasty (TKA) is difficulty in correctly identifying the ankle center. The anterior border of the tibia is easily palpable, as it is not covered by muscles and its shape is convex anteriorly. We hypothesized that appropriate points exist along the anterior border that can be used as landmarks for extramedullary guides. Prior to TKA, computed tomographic images of the entire tibia were obtained from 101 osteoarthritic knees with varus deformities. The relationship between the lines connecting two points on the anterior border and the mechanical axis was evaluated using 3D imaging software. The mean angles between each of 10 determined axes and the mechanical axis varied from 3.28 varus to 2.18 valgus in the coronal plane. In the sagittal plane, all axes referencing the anterior border of the tibia showed anterior inclination to the mechanical axis. The line connecting the medial one-third of the patellar tendon attachment and the distal one-fourth of the anterior border, however, was highly consistent and parallel to the mechanical axis in the coronal plane. This axis can be effectively used as a landmark for extramedullary guides during TKA. ß

IV.

No abstract