Processes of gastrulation in the sea urchin embryo have been intensively studied to reveal the mechanisms involved in the invagination of a monolayered epithelium. It is widely accepted that the invagination proceeds in two steps (primary and secondary invagination) until the archenteron reaches the apical plate, and that the constituent cells of the resulting archenteron are exclusively derived from the veg2 tier of blastomeres formed at the 60-cell stage. However, recent studies have shown that the recruitment of the archenteron cells lasts as late as the late prism stage, and some descendants of veg1 blastomeres are also recruited into the archenteron. In this review, we first illustrate the current outline of sea urchin gastrulation. Second, several factors, such as cytoskeletons, cell contact and extracellular matrix, will be discussed in relation to the cellular and mechanical basis of gastrulation. Third, differences in the manner of gastrulation among sea urchin species will be described; in some species, the archenteron does not elongate stepwise but continuously. In those embryos, bottle cells are scarcely observed, and the archenteron cells are not rearranged during invagination unlike in typical sea urchins. Attention will be also paid to some other factors, such as the turgor pressure of blastocoele and the force generated by blastocoele wall. These factors, in spite of their significance, have been neglected in the analysis of sea urchin gastrulation. Lastly, we will discuss how behavior of pigment cells defines the manner of gastrulation, because pigment cells recently turned out to be the bottle cells that trigger the initial inward bending of the vegetal plate.

The behavior of pigment cells in sea urchin embryos, especially at the gastrula stage, is not well understood, due to the lack of an appropriate method to detect pigment cells. We found that pigment cells emanated autofluorescence when they were fixed with formalin and irradiated with ultraviolet or green light. In Hemicentrotus pulcherrimus, fluorescent pigment cells became visible at the archenteron tip at the mid-gastrula stage. The cells detached from the archenteron slightly before the initiation of secondary invagination and migrated toward the apical plate. Most pigment cells entered the apical plate. This entry site seemed to be restricted, because pigment cells could not enter the ectoderm and remained in the blastocoele at the vegetal pole side when elongation of archenteron was blocked. Pigment cells that had entered the apical plate soon began to migrate in the aboral ectoderm toward the vegetal pole. In contrast, pigment cells of Scaphechinus mirabilis embryos were first detected in the vegetal plate before the onset of gastrulation. Without entering the blastocoele, these cells began to migrate preferentially in the aboral ectoderm toward the animal pole. When the archenteron tip reached the apical plate, pigment cells had already distributed throughout the aboral ectoderm. Thus, the behavior of pigment cells was quite different between H. pulcherrimus and S. mirabilis.

No abstract

The processes of gastrulation in the sand dollar Scaphechinus mirabilis are quite different from those in regular echinoids. In this study, we explored the cellular basis of gastrulation in this species with several methods. Cell-tracing experiments revealed that the prospective endodermal cells were convoluted throughout the invagination processes. Histological observation showed that the ectodermal layer remained thickened, and the vegetal cells retained an elongated shape until the last step of invagination. Further, most of the vegetal ectodermal cells were skewed or distorted. Wedge-shaped cells were common in the vegetal ectoderm, especially at the subequatorial region. In these embryos, unlike the embryos of regular echinoids, secondary mesenchyme cells did not seem to exert the force to pull up the archenteron toward the inner surface of the apical plate. In fact, the archenteron cells were not stretched along the axis of elongation and were in close contact with each other. Here we found that gastrulation was completely blocked when the embryos were attached to a glass dish coated with poly-L-lysine, in which the movement of the ectodermal layer was inhibited. These results suggest that a force generated by the thickened ectoderm, rather than rearrangement of the archenteron cells, may play a key role in the archenteron elongation in S. mirabilis embryos.

Secondary mesenchyme cells (SMCs) of the sea urchin embryo are composed of pigment cells, blastocoelar cells, spicule tip cells, coelomic pouch cells and muscle cells. To learn how and when these five types of SMCs are specified in the veg2 descendants, Notch or Nodal signaling was blocked with γ‐secretase inhibitor or Nodal receptor inhibitor, respectively. All types of SMCs were decreased with DAPT, while sensitivity to this inhibitor varied among them. Pulse‐treatment revealed that five types of SMCs are divided into “early” (pigment cells and blastocoelar cells) and “late” (spicule tip cells, coelomic pouch cells and muscle cells) groups; the “early” group was sensitive to DAPT up to the hatching, and the “late” group was sensitive until the mesenchyme blastula stage. Judging from timing of the shift of Delta‐expressing regions, it was suggested that the “early” group and “late” groups are derived from the lower and the middle tier of veg2 descendants, respectively. Interestingly, numbers of SMCs were also altered with SB431542; blastocoelar cells, coelomic pouch cells and circum‐esophageal muscles decreased, whereas pigment cells and spicule tip cells increased in number. Pulse‐treatment showed that the “early” group was sensitive up to the mesenchyme blastula stage, while the “late” group up to the onset of gastrulation. Thus, it became clear that precursor cells of the “early” and “late” groups, which are located in different regions in the vegetal plate, receive Delta and Nodal signals at different timings, resulting in the diversification of SMCs. Based on the obtained results, the specification processes of five types of SMCs are diagrammatically presented.