Nanofluids—a simple product of the emerging world of nanotechnology—are suspensions of nanoparticles (nominally 1–100 nm in size) in conventional base fluids such as water, oils, or glycols. Nanofluids have seen enormous growth in popularity since they were proposed by Choi in 1995. In the year 2011 alone, there were nearly 700 research articles where the term nanofluid was used in the title, showing rapid growth from 2006 (175) and 2001 (10). The first decade of nanofluid research was primarily focused on measuring and modeling fundamental thermophysical properties of nanofluids (thermal conductivity, density, viscosity, heat transfer coefficient). Recent research, however, explores the performance of nanofluids in a wide variety of other applications. Analyzing the available body of research to date, this article presents recent trends and future possibilities for nanofluids research and suggests which applications will see the most significant improvement from employing nanofluids.

Due to its renewable and nonpolluting nature, solar energy is often used in applications such as electricity generation, thermal heating, and chemical processing. The most cost-effective solar heaters are of the “flat-plate” type, but these suffer from relatively low efficiency and outlet temperatures. The present study theoretically investigates the feasibility of using a nonconcentrating direct absorption solar collector (DAC) and compares its performance with that of a typical flat-plate collector. Here a nanofluid—a mixture of water and aluminum nanoparticles—is used as the absorbing medium. A two-dimensional heat transfer analysis was developed in which direct sunlight was incident on a thin flowing film of nanofluid. The effects of absorption and scattering within the nanofluid were accounted for. In order to evaluate the temperature profile and intensity distribution within the nanofluid, the energy balance equation and heat transport equation were solved numerically. It was observed that the presence of nanoparticles increases the absorption of incident radiation by more than nine times over that of pure water. According to the results obtained from this study, under similar operating conditions, the efficiency of a DAC using nanofluid as the working fluid is found to be up to 10% higher (on an absolute basis) than that of a flat-plate collector. Generally a DAC using nanofluids as the working fluid performs better than a flat-plate collector, however, much better designed flat-plate collectors might be able to match or outperform a nanofluids based DAC under certain conditions.

The present study attempts to improve the ignition properties of diesel fuel by investigating the influence of adding aluminum and aluminum oxide nanoparticles to diesel. As part of this study, droplet ignition experiments were carried out atop a heated hot plate. Different types of fuel mixtures were used; both particle size (15 and 50 nm) as well as the volume fraction (0%, 0.1%, and 0.5%) of nanoparticles added to diesel were varied. For each type of fuel mixture, several droplets were dropped on the hot plate from a fixed height and under identical conditions, and the probability of ignition of that fuel was recorded based on the number of droplets that ignited. These experiments were repeated at several temperatures over the range of 688-768 degrees C. It was observed that the ignition probability for the fuel mixtures that contained nanoparticles was significantly higher than that of pure diesel.

Dispersing trace amounts of nanoparticles into the base-fluid has significant impact on the optical as well as thermo-physical properties of the base-fluid. This characteristic can be utilized in effectively capturing as well as transporting the solar radiant energy. Enhancement of the solar irradiance absorption capacity of the base fluid scales up the heat transfer rate resulting in higher & more efficient heat transfer. This paper attempts to introduce the idea of harvesting the solar radiant energy through usage of nanofluid-based concentrating parabolic solar collectors. In order to theoretically analyze the nanofluid-based concentrating parabolic solar collector (NCPSC) it has been mathematically modeled, and the governing equations have been numerically solved using finite difference technique. The results of the model were compared with the experimental results of conventional concentrating parabolic solar collectors under similar conditions. It was observed that while maintaining the same external conditions (such as ambient/inlet temperatures, wind speed, solar insolation, flow rate, concentration ratio etc.) the NCPSC has about 5–10% higher efficiency as compared to the conventional parabolic solar collector. Furthermore, some parametric studies were carried out which reflected the effect of various parameters such as solar insolation, incident angle, convective heat transfer coefficient etc. on the performance indicators such as thermal efficiency etc.

Dispersing trace amounts of nanoparticles into common base-fluids has a significant impact on the optical as well as thermophysical properties of the base-fluid. This characteristic can be utilized to effectively capture and transport solar radiation. Enhancement of the solar irradiance absorption capacity leads to a higher heat transfer rate resulting in more efficient heat transfer. This paper attempts to introduce the idea of harvesting solar radiant energy through usage of nanofluid-based concentrating parabolic solar collectors (NCPSC). In order to theoretically analyze the NCPSC, it has been mathematically modeled, and the governing equations have been numerically solved using finite difference technique. The results of the model were compared with the experimental results of conventional concentrating parabolic solar collectors under similar conditions. It was observed that while maintaining the same external conditions (such as ambient/inlet temperatures, wind speed, solar insolation, flow rate, concentration ratio, etc.) the NCPSC has about 5–10% higher efficiency as compared to the conventional parabolic solar collector. Furthermore, parametric studies were carried out to discover the influence of various parameters on performance and efficiency. The following parameters were studied in the present study: solar insolation, incident angle, and the convective heat transfer coefficient. The theoretical results clearly indicate that the NCPSC has the potential to harness solar radiant energy more efficiently than a conventional parabolic trough.