Sodium monofluorophosphate (MFP) is a component of fluoride-containing dentifrices and is more biosafe than the conventional sodium fluoride (NaF). MFP can respond not only on the tooth surface layer but also deep into the enamel. We aim to confirm that high concentrations of acid phosphate MFP (AP-MFP, 9000 ppmF), used in professional care, could lead to a highly biosafe fluoride application method that acts through the deep enamel layers. Sample groups were respectively treated in vitro with NaF, acidulated phosphate fluoride (APF), MFP, and AP-MFP, and the samples were compared against an untreated group. Characterizations after fluoride application confirmed that MFP and AP-MFP treatments improved the acid resistance of enamel compared to that of conventional methods. Furthermore, the acid resistance of highly concentrated MFPs improved by using phosphoric acid. Although the acid resistance from the AP-MFP method is not as good as that using APF, AP-MFP can act both on the surface layer and deep into the enamel. Moreover, AP-MFP retains fluoride ions as much as APF does on the tooth surface. The proposed fluoride application method using AP-MFP introduces a dental treatment for acid resistance that is highly biosafe and penetrates deep layers of the enamel.

In this study, we attempted to develop a dental caries prevention method using a bioapatite (BioHap), an eggshell-derived apatite with nanoparticle size and biocompatibility, with a high-concentration fluoride tooth surface application method. The enamel acid resistance after the application of the proposed method was compared with that of a conventional topical application of fluoride using bovine tooth enamel as an example. The tooth samples were divided into three groups based on the preventive treatment applied, and an acid challenge was performed. The samples were evaluated for acid resistance using qualitative and quantitative analytical methods. The BioHap group demonstrated reduced enamel loss and improved micro-Vickers hardness, along with a thick coating layer, decreased reaction area depth, and decreased mineral loss value and lesion depth. The combination of BioHap with high-concentration fluoride led to the formation of a thick coating layer on the enamel surface and better suppression of demineralization than the conventional method, both qualitatively and quantitatively. The proposed biocompatible nano-hydroxyapatite coating method is expected to become a new standard for providing professional care to prevent dental caries.

Sodium monofluorophosphate (Na2FPO3, MFP) is mainly used as an ingredient in fluoride-based dentifrices as it has a high safety profile, with one-third of the toxicity of sodium fluoride (NaF), as well as the ability to reach deep into the dentin. The purpose of this study was to assess the prevention of dentin erosion by MFP upon exposure to citric acid, which has a chelating effect, and to compare the effects to those of the conventional acidulated phosphate fluoride (APF) application method. Bovine dentin was used, and four groups were created: (i) APF (9000 ppmF, pH 3.6) 4 min group; (ii) acidulated phosphate MFP (AP-MFP, 9000 ppmF, pH 3.6) 4 min group; (iii) AP-MFP 2 min + APF 2 min (dual) group; and (iv) no fluoride application (control) group. Compared with the conventional APF application method, the application of AP-MFP was shown to significantly reduce substantial defects, mineral loss, and lesion depth; better maintain Vickers hardness; and promote the homogenous aggregation of fine CaF2 particles to seal the dentin tubules, enhancing acid resistance in their vicinity. The ΔZ value of the AP-MFP group was 2679 ± 290.2 vol% μm, significantly smaller than the APF group’s 3806 ± 257.5 vol% μm (p < 0.01). Thus, AP-MFP-based fluoride application could effectively suppress citric acid-induced demineralization and could become a new, more powerful, and biologically safer professional-care method for preventing acid-induced dentin erosion than the conventional method.