The electrochemical oxidation behaviors of the surfaces of platinum nanoparticles, one of the key phenomena in fuel cell developments, were investigated in situ and in real time, via time-resolved hard X-ray diffraction and energy dispersive X-ray absorption spectroscopy. Combining two complementary structural analyses, dynamical and inhomogenous structural changes occurring at the surfaces of nanoparticles were monitored on an atomic level with a time resolution of less than 1 s. After oxidation at 1.4 V vs RHE (reversible hydrogen electrode) in a 0.5 M H(2)SO(4) solution, longer Pt-O bonds (2.2-2.3 A that can be assigned to OHH and/or OH species) were first formed on the surface through the partial oxidation of water molecules. Next, these species turned to shorter Pt-O bonds (2.0 A, adsorbed atomic oxygen), and atomic oxygen was incorporated into the inner part of the nanoparticles, forming an initial monolayer oxide that had alpha-PtO(2)-like local structures with expanded Pt-Pt bonds (3.1 A). Finally, quasi-three-dimensional oxides with longer Pt-(O)-Pt bonds (3.5 A, precursor for beta-PtO(2)) grew on the surface, at almost 100 s after oxidation. Despite the very complex oxidation mechanism on the atomic level, XANES analysis indicated that the charge transfer from platinum to the adsorbed oxygen species was almost constant and rather small, that is, about 0.5 electrons per oxygen, up to two monolayers of oxygen. This means that ionic polarization hardly develops at this stage of the surface platinum's "oxide" growth.

No abstract

A TiS 2 crystal with a layered structure was found to have a large thermoelectric power factor. The in-plane power factor S 2 /ρ at 300 K is 37.1 µW/K 2 cm with resistivity (ρ) of 1.7 mΩcm and thermopower (S) of -251 µV/K, and this value is comparable to that of the best thermoelectric material, Bi 2 Te 3 alloy.The electrical resistivity shows both metallic and highly anisotropic behaviors, suggesting that the electronic structure of this TiS 2 crystal has a quasi-twodimensional nature. The large thermoelectric response can be ascribed to the large density of state just above the Fermi energy and inter-valley scattering.In spite of the large power factor, the figure of merit, ZT of TiS 2 is 0.16 at 300 K, because of relatively large thermal conductivity, 68 mW/Kcm. However, most of this value comes from reducible lattice contribution. Thus, ZT can be improved by reducing lattice thermal conductivity, e.g., by introducing a rattling unit into the inter-layer sites.

Solid silicon monoxide is an amorphous material which has been commercialized for many functional applications. However, the amorphous structure of silicon monoxide is a long-standing question because of the uncommon valence state of silicon in the oxide. It has been deduced that amorphous silicon monoxide undergoes an unusual disproportionation by forming silicon- and silicon-dioxide-like regions. Nevertheless, the direct experimental observation is still missing. Here we report the amorphous structure characterized by angstrom-beam electron diffraction, supplemented by synchrotron X-ray scattering and computer simulations. In addition to the theoretically predicted amorphous silicon and silicon-dioxide clusters, suboxide-type tetrahedral coordinates are detected by angstrom-beam electron diffraction at silicon/silicon-dioxide interfaces, which provides compelling experimental evidence on the atomic-scale disproportionation of amorphous silicon monoxide. Eventually we develop a heterostructure model of the disproportionated silicon monoxide which well explains the distinctive structure and properties of the amorphous material.

No abstract

Available methods to analyze proton conduction mechanisms cannot distinguish between two proton-conduction processes derived from the Grotthuss mechanism. The two mechanistic variations involve structural diffusion, for which water movement is indispensable, and the recently proposed "packed-acid mechanism," which involves the conduction of protons without the movement of water and is typically observed in materials consisting of highly concentrated (packed) acids. The latter mechanism could improve proton conductivity under low humidity conditions, which is desirable for polymer electrolyte fuel cells. We proposed a method with which to confirm quantitatively the packed-acid mechanism by combining (2)H and (17)O solid-state magic-angle-spinning nuclear magnetic resonance (MAS-NMR) measurement and (1)H pulsed-field gradient (PFG)-NMR analysis. In particular, the measurements were performed below the water-freezing temperature to prevent water movement, as confirmed by the (17)O-MAS-NMR spectra. Even without water movement, the high mobility of protons through short- and long-range proton conduction was observed by using (2)H-MAS-NMR and (1)H-PFG-NMR techniques, respectively, in the composite of zirconium sulfophenylphosphonate and sulfonated poly(arylene ether sulfone) (ZrSPP-SPES), which is a material composed of highly concentrated acids. Such behavior contrasts with that of a material conducting protons through structural diffusion or vehicle mechanisms (SPES), in which the peaks in both (2)H and (17)O NMR spectra diminished below water-freezing temperature. The activation energies of short-range proton movement are calculated to be 2.1 and 5.1 kJ/mol for ZrSPP-SPES and SPES, respectively, which indicate that proton conduction in ZrSPP-SPES is facilitated by the packed-acid mechanism. Furthermore, on the basis of the mean-square displacement using the diffusivity coefficient below water-freezing temperature, it was demonstrated that long-range proton movement, of the order of 1.3 μm, can take place in the packed-acid mechanism in ZrSPP-SPES.

Tantalum-oxide-based oxygen-reduction-reaction (ORR) catalysts have the ORR activity only when they are synthesized from tantalum carbonitrides. Namely pure Ta 2 O 5 does not show ORR activity, and carbon or nitrogen in precursors is inevitable to form ORR active sites and to promote ORR. To clarify this reason, we investigated structural and surface electronic properties of tantalum-oxide-based catalysts, which were synthesized by gradually oxidizing tantalum carbonitride under low partial pressure of oxygen at 1000 °C, by using X-ray absorption spectroscopy, transmission electron microscopy, and Raman spectroscopy. The results indicate that oxidized tantalum carbonitrides with high ORR activity had oxygen vacancies near the surface, indicating that the vacancies could work as an active site for ORR. We also found that carbon was deposited on the oxide's surface during oxidation of tantalum carbonitrides. The deposited carbon seems to play two important roles in formation of oxygen vacancies (ORR active sites) providing reductive atmosphere, and in producing electron conduction paths on rather insulating oxides' surface.

The electronic structure and modification of the local interatomic structure of a reactive sputtered amorphous tantalum oxide (a-TaO(x)) thin film with the variation of oxygen nonstoichiometry, x in a-TaO(x) have been investigated by X-ray absorption spectroscopy (XAS), X-ray photoemission spectroscopy (XPS), Raman scattering spectroscopy, and Rutherford back scattering spectroscopy. A parallel chemical shift of Ta4f(7/2) and O1s core levels observed with the variation of x indicates the Fermi level shift by reduction and oxidation in the framework of the rigid band model. Extended X-ray absorption fine structure (EXAFS) suggests both the increase of average coordination number of the first Ta-O shell in polyhedra and a considerable reduction of the average Ta-O bond length with the increase of x. The relative intensity of Raman shift peaks at 670 cm(-1) and 815 cm(-1), corresponding to Ta-O stretching of TaO(6) octahedra and TaO(5) probably with a pyramidal form, respectively, drastically changes between x = 2.47 to 1.86, suggesting the change in the predominant polyhedron from TaO(6) to TaO(5) with a modification in multiplicity of oxygen by the reorganization of the polyhedral network.