Uncertainty exists on whether Parkinson's disease (PD) and essential tremor (ET) patients have similar degree of impairment during motor tasks. We investigated this problem by analyzing nonlinear dynamics of repetitive movements in 21 control subjects, 33 mild-moderate PD patients, and 18 ET patients. Accelerometer signals were recorded during finger tapping and unbounded forearm movements between two points, and processed with moving average filtering to generate a new signal consisting of the temporal distance between consecutive cycles. We calculated: mean interpeak interval (slowness), interpeak interval variability (irregularity), and beat decay (BD) of the auto mutual information (AMI) value, which estimates signal predictability by measuring the loss of signal information over a timescale. Both PD and ET had longer interpeak interval (except for finger tapping), higher interpeak interval variability, and higher BD-AMI values than controls (P ≤ 0.007, all comparisons). ET patients had higher BD-AMI values than PD (P = 0.003). BD-AMI was the parameter that discriminated better between subjects (diagnosis accuracies about 80%). No differences existed between PD patients with and without tremor or between PD or ET patients with different disease stages, for any parameter. Evaluation of nonlinear dynamics of oscillatory repetitive movements is a feasible and promising tool for studying movement physiology. Movement performance is more predictable in PD and ET than in controls, even in early disease stages. Slowness and irregularity of movement in PD and ET cannot be fully explained by tremor. Some common pathogenic mechanisms leading to bradykinesia may contribute to this impairment.

No abstract

The effect of electropulsing treatment (EPT) on the surface general corrosion behavior of an AISI/SAE 1045 steel under different machining regimes is studied. In the study, the following variables are alternated: high-speed steel (HSS) vs. hard metal (HM), and with and without the assistance of high-density electropulses. The corrosion rates are determined using comparative studies such as gravimetric analysis, salt spray chamber test, electrochemical polarization curve techniques (PC), and linear polarization resistance (LPR). Differences in surface microhardness were evaluated by applying optical microscopy and planimetric procedures. Specimens subjected to electropulses and turned with HM reported greater reductions of corrosion rates. Changes in corrosion behavior can be explained in terms of grain shape factor h variation. The present study demonstrates that electropulsing affects the corrosion behavior of AISI/SAE 1045 steel after the turning process.