No abstract

The static chamber method (non-flow-through-non-steady-state chambers) is the most common method to measure fluxes of methane (CH4) from soils. Laboratory comparisons to quantify errors resulting from chamber design, operation and flux calculation methods are rare. We tested fifteen chambers against four flux levels (FL) ranging from 200 to 2300 mu g CH4 M-2 II-1. The measurements were conducted on a calibration tank using three quartz sand types with soil porosities of 53% (dry fine sand, S1), 47% (dry coarse sand, S2), and 33% (wetted fine sand, S3). The chambers tested ranged from 0.06 to 1.8 m in height, and 0.02 to 0.195 m(3) in volume, 7 of them were equipped with a fan, and 1 with a vent-tube. We applied linear and exponential flux calculation methods to the chamber data and compared these chamber fluxes to the reference fluxes from the calibration tank. The chambers underestimated the reference fluxes by on average 33% by the linear flux calculation method (R-Iin), whereas the chamber fluxes calculated by the exponential flux calculation method (R-exp) did not significantly differ from the reference fluxes (p <0.05). The flux under- or overestimations were chamber specific and independent of flux level. Increasing chamber height, area and volume significantly reduced the flux underestimation (p <0.05). Also, the use of non-linear flux calculation method significantly improved the flux estimation; however, simultaneously the uncertainty in the fluxes was increased. We provide correction factors, which can be used to correct the under- or overestimation of the fluxes by the chambers in the experiment. (C) 2012 Elsevier B.V. All rights reserved

Abstract. This paper describes the background, instrumentation, goals, and the regional influences on the HUMPPA-COPEC intensive field measurement campaign, conducted at the Boreal forest research station SMEAR II (Station for Measuring Ecosystem-Atmosphere Relation) in Hyytiälä, Finland from 12 July-12 August 2010. The prevailing meteorological conditions during the campaign are examined and contrasted with those of the past six years. Back trajectory analyses show that meteorological conditions at the site in 2010 were characterized by a higher proportion of southerly flow than in the other years studied. As a result the summer Correspondence to: J. Williams (jonathan.williams@mpic.de) of 2010 was anomalously warm and high in ozone making the campaign relevant for the analysis of possible future climates. A comprehensive land use analysis, provided on both 5 and 50 km scales, shows that the main vegetation types surrounding the site on both the regional and local scales are: coniferous forest (Scots pine and/or Norway spruce); mixed forest (Birch and conifers); and woodland scrub (e.g. Willows, Aspen); indicating that the campaign results can be taken as representative of the Boreal forest ecosystem. In addition to the influence of biogenic emissions, the measurement site was occasionally impacted by sources other than vegetation. Specific tracers have been used here to identify the time periods when such sources have impacted the site namely: biomass burning (acetonitrile and CO), urbanPublished by Copernicus Publications on behalf of the European Geosciences Union. 10600 J. Williams et al.: An overview of meteorological and chemical influences anthropogenic pollution (pentane and SO 2 ) and the nearby Korkeakoski sawmill (enantiomeric ratio of chiral monoterpenes). None of these sources dominated the study period, allowing the Boreal forest summertime emissions to be assessed and contrasted with various other source signatures.

No abstract

Abstract. Estimates of volatile organic compound (VOC)emissions from forests are based on the assumption that foliage has a steady emission potential over its lifetime, and that emissions are mainly modified by short-term variations in light and temperature. However, in many field studies this has been challenged, and high emissions and atmospheric concentrations have been measured during periods of low biological activity, such as in springtime. We conducted measurements during three years, using an online gas-exchange monitoring system to observe volatile organic emissions from a mature (1 year-old) and a growing Scots pine shoot. The emission rates of organic vapors from vegetative buds of Scots pine during the dehardening and rapid shoot growth stages were one to two orders of magnitude higher than those from mature foliage; this difference decreased and finally disappeared when the new shoot was maturing in late summer. On average, the springtime monoterpene emission rate of the bud was about 500 times higher than that of the mature needles; during the most intensive needle elongation period, the monoterpene emission rate of the growing needles was 3.5 higher than that of the mature needles, and in September the monoterpene emission rate of the same years' needles was even lower (50 %) than that of the previous years' needles. For other measured compounds (methanol, acetone and methylbutenol) the values were of the same order of magnitude, except before bud break in spring, when the emission rates of buds for those compounds were on average about 20-30 times higher than that of mature needles. During spring and early summer the buds and growing shoots are a strong source of several VOCs, and if they are not accounted for in emission modeling a significant proportion of the emissions -from a few percent to even half of the annual cumulative emissions -will remain concealed. The diurnal emission pattern of growing shoots differed from the diurnal cycle in temperature as well as from the diurnal emission pattern of mature shoots, which may be related to processes involved in shoot or needle elongation. Our findings imply that global estimations of monoterpene emission rates from forests are in need of revision, and that the physiological state of the plants should be taken into account when emissions of the reactive gases such as monoterpenes are estimated.

No abstract

No abstract

Abstract. Aromatic hydrocarbons are associated with direct adverse human health effects and can have negative impacts on ecosystems due to their toxicity, as well as indirect negative effects through the formation of tropospheric ozone and secondary organic aerosol, which affect human health, crop production and regional climate. Measurements of aromatic hydrocarbons were conducted at the Welgegund measurement station (South Africa), which is considered to be a regionally representative background site. However, the site is occasionally impacted by plumes from major anthropogenic source regions in the interior of South Africa, which include the western Bushveld Igneous Complex (e.g. platinum, base metal and ferrochrome smelters), the eastern Bushveld Igneous Complex (platinum and ferrochrome smelters), the Johannesburg-Pretoria metropolitan conurbation (> 10 million people), the Vaal Triangle (e.g. petrochemical and pyrometallurgical industries), the Mpumalanga Highveld (e.g. coal-fired power plants and petrochemical industry) and also a region of anticyclonic recirculation of air mass over the interior of South Africa. The aromatic hydrocarbon measurements were conducted with an automated sampler on Tenax-TA and Carbopack-B adsorbent tubes with heated inlet for 1 year. Samples were collected twice a week for 2 h during daytime and 2 h during night-time. A thermal desorption unit, connected to a gas chromatograph and a mass selective detector was used for sample preparation and analysis. Results indicated that the monthly median (mean) total aromatic hydrocarbon concentrations ranged between 0.01 (0.011) and 3.1 (3.2) ppb. Benzene levels did not exceed the local air quality standard limit, i.e. annual mean of 1.6 ppb. Toluene was the most abundant compound, with an annual median (mean) concentration of 0.63 (0.89) ppb. No statistically significant differences in the concentrations measured during daytime and night-time were found, and no distinct seasonal patterns were observed. Air mass back trajectory analysis indicated that the lack of seasonal cycles could be attributed to patterns determining the origin of the air masses sampled. Aromatic hydrocarbon concentrations were in general significantly higher in air masses that passed over anthropogenically impacted regions. Inter-compound correlations and ratios gave some indications of the possible sources of the different aromatic hydrocarbons in the source regions defined in the paper. The highest contribution of aromatic hydrocarbon concentrations to ozone formation potential was also observed in plumes passing over anthropogenically impacted regions.