Injectable hydrogels are useful for numerous biomedical applications, such as to introduce therapeutics into tissues or for 3D printing. To expand the complexity of available injectable hydrogels, shear-thinning and self-healing granular hydrogels are developed from microgels that interact via guest-host chemistry. The microgel properties (e.g., degradation, molecule release) are tailored through their crosslinking chemistry, including degradation in response to proteases. When microgels of varied formulations are mixed, complex release and degradation behaviors are observed, including after injection to permit cellular invasion.

Microfluidic chips can generate emulsions, which can be used to synthesize polymer microparticles that have superior pharmacological performance compared to particles prepared by conventional techniques. However, low production rates of microfluidics remains a challenge to successfully translate laboratory discoveries to commercial manufacturing. We present a silicon and glass device that incorporates an array of 10,260 (285 × 36) microfluidic droplet generators that uses only a single set of inlets and outlets, increasing throughput by >10,000× compared to microfluidics with a single generator. Our design breaks the tradeoff between the number of generators and the maximum throughput of individual generators by incorporating high aspect ratio flow resistors. We test these design strategies by generating hexadecane microdroplets at >1 trillion droplets per h with a coefficient of variation CV <3%. To demonstrate the synthesis of biocompatible microparticles, we generated 8–16 µm polycaprolactone particles with a CV <5% at a rate of 277 g h−1.

Droplet-based microfluidics has led to transformational new approaches in diverse areas including materials synthesis and high-throughput biological assays. However, the translation of droplet microfluidics technology into commercial applications requires scale-up of droplet generation from the laboratory (<10 mL h(-1)) to the industrial (>1 L h(-1)) scale. To address this challenge, we develop a three-dimensional monolithic elastomer device (3D MED) for mass production of monodisperse emulsion droplets. Using double-sided imprinting, 3D microchannels are formed in a single elastomer piece that has 1000 parallel flow focusing generators (k-FFGs). Compared to previous work that parallelizes droplet generation, the 3D MED eliminates the needs for alignment and bonding of multiple pieces and thus makes it possible to achieve the high flow rates and pressure necessary for the kilo-scale generation of droplets. Using this approach, we demonstrate mass production of water-in-oil (W/O) emulsion droplets at production rates as high as 1.5 L h(-1) (>30 billion 45 μm diameter droplets per hour), with a coefficient of variation of droplet diameter of only 6.6%. Because of the simplicity, robustness, and manufacturability of our 3D MED architecture, it is well suited to bridge the gap between the continuously growing library of promising microfluidic technologies to generate microparticles that have been demonstrated in laboratory settings and their successful application in industry.