A 1 min multicontrast brain MRI scan based on EPI readouts has been presented in this feasibility study. Preliminary data show potential for clinical brain MRI use with minimal bore time for the patient. Such short examination time could be useful (e.g., for screening and acute stroke). The sequence may also help planning conventional brain MRI scans if run at the beginning of an examination. Magn Reson Med 79:3045-3054, 2018. © 2017 International Society for Magnetic Resonance in Medicine.

Funding information GE HealthcarePurpose: To investigate the use of 3D EPI for rapid T 1 -weighted brain imaging, focusing on the RF pulse's influence on the contrast between gray and white matter. Methods: An interleaved 3D EPI sequence use partial Fourier and CAIPIRINHA sampling was used to acquire T 1 -weighted brain volumes with isotropic resolution, low echo times, and low geometric distortions. Five different RF pulses were evaluated in terms of fat suppression performance and gray-white matter contrast. Two binomial RF pulses were compared to a single rectangular (WE-rect) RF pulse exciting only water, and two new RF pulses developed in this work, where one was an extension of the WE-rect, and the other was an SLR pulse. The technique was demonstrated in three clinical cases, where brain tumor patients were imaged before and after gadolinium administration. Results: A fat-suppressed 3D EPI sequence with a phase encoding bandwidth of around 100 Hz was found to exhibit a good trade-off between geometrical distortions and scan duration. Whole-brain T 1 -weighted 3D EPI images with 1.2 mm isotropic voxel size could be acquired in 24 seconds. The WE-rect, its extension, and the SLR RF pulses resulted in reduced magnetization transfer effects and provided a 20% mean increase in gray-white matter contrast. Conclusion: Using a high phase encoding bandwidth and RF pulses that reduce magnetization transfer effects, a fat-suppressed multi-shot 3D EPI sequence can be used to rapidly acquire isotropic T 1 -weighted volumes.

Purpose: To develop reconstruction methods for improved image quality of chemical shift displacement-corrected fat/water imaging combined with partial Fourier acquisition. Theory: Fat/water separation in k-space enables correction of chemical shift displacement. Modeling fat and water as real-valued rather than complex improves the conditionality of the inverse problem. This advantage becomes essential for k-space separation. In this work, it was described how to perform regularized fat/water imaging with real estimates in k-space, and how fat/water imaging can be combined with partial Fourier reconstruction using Projection Onto Convex Sets (POCS). Methods: The reconstruction methods were demonstrated on chemical shift encoded gradient echo and fast spin echo data from volunteers, acquired at 1.5 T and 3 T. Both fully sampled and partial Fourier acquisitions were made. Data was retrospectively rejected from the fully sampled dataset to evaluate POCS and homodyne reconstruction. Results: Fat/water separation in k-space eliminated chemical shift displacement, while real-valued estimates considerably reduced the noise amplification compared to complex estimates. POCS reconstruction could recover high spatial frequency information in the fat and water images with lower reconstruction error than homodyne. Partial Fourier in the readout direction enabled more flexible choice of gradient echo imaging parameters, in particular image resolution. Conclusion: Chemical shift displacement-corrected fat/water imaging can be performed with regularization and real-valued estimates to improve image quality by reducing ill-conditioning of the inverse problem in k-space. Fat/water imaging can be combined with POCS, which offers improved image quality over homodyne reconstruction. K E Y W O R D S artifact correction, chemical shift imaging, Dixon, fat-water separation, partial Fourier, POCS 654 | BERGLUND Et aL.