The review addresses the influence of polyelectrolytes on the stabilisation of free-standing liquid foam films, which affects the stability of a whole macroscopic foam. Both the composition of the film surface and the stratification of the film bulk drives the drainage and the interfacial forces within a foam film.Beside synthetic polyelectrolytes also natural polyelectrolytes like cellulose, proteins and DNA are considered.

The complexation, surface adsorption, and foam film stabiliztation of the oppositely charged surfactants, sodium dodecyl sulfate (SDS) and dodecyl trimethylammonium bromide (C12TAB), is analyzed. The SDS:C12TAB mixing ratio is systematically varied to investigate whether the adsorption of equimolar or irregular catanionic surfactant complexes, and thus a variation in surface charge (i.e., surface excess of either SDS or C12TAB), governs foam film properties. Surface tension measurements indicate that SDS and C12TAB interact electrostatically in order to form stoichometric catanionic surfactant complexes and enhance surface adsorption. On the other hand it can be demonstrated that the SDS:C12TAB mixing ratio and, thus, a change in surface charge and composition plays a decisive role in foam film stabilization. The present study demonstrates that varying the mixing ratio between SDS and C12TAB offers a tool for tailoring surface composition and foam film properties, which are therefore not exclusively mediated by the presence of equimolar catanionic surfactant complexes. The SDS:C12TAB net amount and mixing ratio determine the type, stability, and thinning behavior of the corresponding foam film. These observations indicate the formation of a mixed surface layer, composed of the catanionic surfactant species surrounded by either free SDS or C12TAB molecules in excess. Furthermore, a systematic variation in CBF-NBF transition kinetics is rationalized on the basis of a microscopic phase transition within the foam films. Fundamental knowlegde gained from this research gives insight into the surface adsorption and foam film formation of catanionic surfactant mixtures. The study helps researchers to understand basic mechanisms of foam film stabilization and to use resources more efficiently.

We have studied the oppositely charged polyelectrolyte/surfactant mixture of poly(acrylamidomethylpropanesulfonate) sodium salt (PAMPS) and tetradecyl trimethylammonium bromide (C14TAB) using a combination of neutron reflectivity and ellipsometry measurements. The interfacial composition was determined using three different analysis methods involving the two techniques for the first time. The bulk surfactant concentration was fixed at a modest value while the bulk polyelectrolyte concentration was varied over a wide range. We reveal complex changes in the surface adsorption behavior. Mixtures with low bulk PAMPS concentrations result in the components interacting synergistically in charge neutral layers at the air/water interface. At the bulk composition where PAMPS and C14TAB are mixed in an equimolar charge ratio in the bulk, we observe a dramatic drop in the surfactant surface excess to leave a large excess of polyelectrolyte at the interface, which we infer to have loops in its interfacial structure. Further increase of the bulk PAMPS concentration leads to a more pronounced depletion of material from the surface. Mixtures containing a large excess of PAMPS in the bulk showed enhanced adsorption, which is attributed to the large increase in total ionic strength of the system and screening of the surfactant headgroup charges. The data are compared to our former results on PAMPS/C14TAB mixtures [Kristen et al. J. Phys. Chem. B, 2009, 23, 7986]. A peak in the surface tension is rationalized in terms of the changing surface adsorption and, unlike in more concentrated systems, is unrelated to bulk precipitation. Also, a comparison between the determined interfacial composition with zeta potential and foam film stability data shows that the highest film stability occurs when there is enhanced synergistic adsorption of both components at the interface due to charge screening when the total ionic strength of the system is highest. The additional contribution to the foam stability of the negatively charged polyelectrolyte within the film bulk is also discussed.

No abstract

No abstract

No abstract

No abstract

No abstract