In this study, a post-tensioning method using externally unbonded steel rods was applied to pre-damaged reinforced concrete beams for flexural strengthening. Nine simply-supported beams, three reference beams and six post-tensioned beams, were subjected to three-point bending. The design parameters observed in this study were the amount of tension reinforcements (3-D19, 4-D19, and 2-D22 + 2-D25; “D” indicates the nominal diameter of the rebar) and the diameters of the external rod (φ22 mm and φ28 mm). A V-shaped profile with a deviator at the bottom of the mid-span was applied to the pre-damaged beams, and a post-tensioning force was added to overcome the low load resistance and deflection already incurred in the pre-loading state. The post-tensioning force caused by tightening the nuts at the anchorage corresponded to a strain of 2000 με in the external rods; this value was approximately equal to the strain caused by torque that two adults can apply conveniently. The post-tensioning system increased the load-carrying capacity and flexural stiffness by approximately 40–112% and 28–73%, respectively, when compared with the control beams. However, the external rods did not yield in the post-tensioned beam with larger steel reinforcements and external steel rods. The external rod with the larger diameter increased the flexural strength more effectively.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.