In this work, we demonstrate refractive index (RI) sensors based on the cascade of hetero-core structures using multimode and no-core optical fibers in sequence. The sensor device is engineered to have resonances at different wavelengths using different sensing region lengths. The device fabrication involves simple fiber cleaving and fusion splicing. For the experiments, the two sensor regions are exposed to liquids with different RIs. For the hetero-core fiber insertion length of 45 mm, the transmission valley is centered at 1082.5 nm with 15.1 nm full width at half-maximum (FWHM) for an external medium RI of 1.3370. Additionally, it shifts 4.1 nm towards longer wavelengths as the RI of the external medium increases to 1.3840. For the 30 mm long hetero-core structure, the valley is centered at 1599.7 nm with 23.3 nm FWHM for an external medium RI of 1.3370, which shifts 7.4 nm as the RI increases to 1.3840. The sensor sensitivities are up to − 476 d B / r e f r a c t i v e index unit (RIU) and 270 nm/RIU. The resolution of the devices is estimated to be 2 × 10 − 5 R I U .

No abstract

In this paper, a new optical fiber corrosion sensor based on metallic bilayers is described. The detection region is located at a fiber end facet and we present simulations as well as experimental results in controlled lab conditions for Ti(10 nm)/Al(10 nm) and Ni(5 nm)/Al(5 nm) bilayers. We perform the characterization of the device by numerical simulations using the COMSOL Multiphysics software, and with an analytical model, which makes use of the Fresnel equations. According to the simulations, the change in the reflected optical signal over time is related to variations in the thickness of the metallic films by the corrosive process and, consequently, the corrosion rate in each metal of the bilayer can be obtained. Upon the simulation results, sensor devices were fabricated by depositing thin metallic films on the cleaved facet of the optical fiber using the sputtering method. We show that the use of a metallic bilayer as a transducer, instead of a monolayer, improves the sensor measuring interval (20 ± 1 nm) and provides information about the corrosion rate along the corrosion process.

Due to the vast area of application and reliability, fiber optic magnetic field sensors have been the subject of several studies, however, some of these application areas are submitted to temperature variations, which can hinder the sensors in monitoring the magnetic field. With this panorama, this work analyzes through computational modeling a fiber optical magnetic field sensor, using the magneto-optical Faraday effect and observing temperature effects in the sensor response. For modeling, a numerical model built in COMSOL Multiphysics is used. The results show a value for cross-sensitivity of 3.27 mT/°C in a non-optimized configuration of the sensor and of 2.47 mT/°C for an optimized configuration. A methodology for optimizing the sensor to operate in a certain temperature range, 55 to 75 °C, is also discussed. The results presented in this work show that the temperature is an important factor to be considered to improve the selectivity and to obtain the correct sensitivity of the sensor.

No abstract