No abstract

Purpose -The purpose of this study is to determine interfacial convective heat transfer coefficient numerically, for a porous media consisting of square blocks in inline arrangement under mixed convection heat transfer.Design/methodology/approach -The continuity, momentum and energy equations are solved in dimensionless form for a representative elementary volume of porous media, numerically. The velocity and temperature fields for different values of porosity, Ri and Re numbers are obtained. The study is performed for the range of Ri number from 0.01 to 10, Re number from 100 to 500 and porosity value from 0.51 to 0.96. Based on the obtained results, the value of the interfacial convective heat transfer coefficient is calculated by using volume average method.Findings -It was found that at low porosities (such as 0.51), the interfacial Nusselt number does not considerably change with Ri and Re numbers. However, for porous media with high Ri number and porosity (such as 10 and 0.51, respectively), secondary flows occur in the middle of the channel between rods improving heat transfer between solid and fluid, considerably. It is shown that the available correlations of interfacial heat transfer coefficient suggested for forced convection can be used for mixed convection for the porous media with low porosity (such as 0.51) or for the flow with low Ri number (such as 0.01).Originality/value -To the best of the authors' knowledge, there is no study on determination of interfacial convective heat transfer coefficient for mixed convection in porous media in literature. The present study might be the first study providing an accurate idea on the range of this important parameter, which will be useful particularly for researchers who study on mixed convection heat transfer in porous media, macroscopically.

Volume averaged thermal transport properties of two metal foams with 10 and 20 PPI are obtained by using microtomography technique. The digital 3D structures of samples are generated in computer environment. The governing equations are solved for the entire domain and the volume averaged technique is used to determine interfacial heat transfer coefficient, longitudinal and transverse thermal dispersion conductivity. The study is performed for the pore scale Reynolds number from 100 to 600. The obtained results are within the ranges of the suggested correlations in literature. The present study supports the correlations suggested by Calmidi and Mahajan (2000) and Zhang et al. (2016).

Laminar mixed convection in a two-dimensional symmetrically and partially heated vertical channel is investigated. The heaters are located on both walls and uniform temperature is applied on the heated sections. The number of heaters is considered as 1, 4, 8, and 10. Aluminum oxide/water nanofluid is considered as working fluid and the inlet velocity is uniform. The continuity, momentum and energy equations with appropriate boundary conditions are solved in dimensionless form, numerically. The study is performed for Richardson number of 0.01 and 10, Reynolds number of 100 and 500, and nanofluid volume fraction of 0% and 5%. Based on the obtained velocity and temperature distributions, the local and mean Nusselt number is calculated and plotted for different cases. The variation of the mean Nusselt number with the number of the heated portions is also discussed. It is found that the addition of nanoparticles into the base fluid increases mean Nusselt number but the rate of increase depends on Reynolds, Richardson numbers and number of heated portions. It is possible to increase mean Nusselt number 138% by increasing Reynolds number from 100 to 500, Richardson number from 0.01 to 10 and number of heated portions from 1 to 10 when volume fraction value is 5%.