Interface engineering has become a vital method in accelerating the development of perovskite solar cells in the past few years. To investigate the effect of different contacted surfaces of a light absorber with an electron transporting layer, TiO2, we synthesize CsPbBr3/TiO2 thin films with two different interfaces (CsBr/TiO2 and PbBr2/TiO2). Both interfacial heterostructures exhibit enhanced visible light absorption, and the CsBr/TiO2 thin film presents higher absorption than the PbBr2/TiO2 interface, which is attributed to the formation of interface states and the decreased interface bandgap. Furthermore, compared with the PbBr2/TiO2 interface, CsBr/TiO2 solar devices present larger output short circuit current and shorter photoluminescence decay time, which indicates that the CsBr contacting layer with TiO2 can better extract and separate the photo-induced carriers. The first-principles calculations confirm that, due to the existence of staggered gap (type II) offset junction and the interface states, the CsBr/TiO2 interface can more effectively separate the photo-induced carriers and thus drive the electron transfer from the CsPbBr3 perovskite layer to the TiO2 layer. These results may be beneficial to exploit the potential application of all-inorganic perovskite CsPbBr3-based solar cells through the interface engineering route.
Double perovskites Cs2AgSbCl6 have been synthesized via the solution state for applications as a promising photovoltaic absorber. Considering TiO2 as an electron transport layer (ETL), Cs2AgSbCl6/TiO2 heterojunction nanoparticles have also been prepared by the hydrothermal process to study the interface effect. Experimental measurements show that Cs2AgSbCl6 has a cubic structure with the lattice constant of 10.699 Å. The absorption peaks in the optical spectrum of the Ag and Sb-based double perovskites agree well with our density functional theory calculations. The Cs2AgSbCl6/TiO2 heterostructure exhibits enhanced optical absorption in the visible-light region compared to that of Cs2AgSbCl6, which is caused by the formation of the interface states and the decreased bandgap, thus facilitating the photo-induced optical transition in the visible-light region. From the charge transfer analysis of two interfaces (Ag2Sb2Cl8/TiO2 and Cs4Cl4/TiO2 interfaces), we find that the efficient separation of photo-induced carriers can be achieved at the Cs4Cl4/TiO2 interface, with electron flowing from the double perovskite layer to the TiO2 ETL, which is beneficial for improving the power conversion efficiency of solar cells. The combined study of theory and experiments indicates that the double perovskites Cs2AgSbCl6 would be a promising light-absorbing material in contact with TiO2 for the lead-free perovskite-based solar cell devices.
We have studied the excess oxygen content and hole concentration in 110 ± C annealed La 2 CuO 41d prepared by electrochemical oxidation for 0 , d , 0.12. Two distinct sites were observed with doping efficiency of 2 or 1.3 holes per excess oxygen atom. The occupation of the two different sites is determined by a critical carrier concentration P c ഠ 0.06. As a consequence, a sudden increase of chemical potential of doped holes at P c is suggested. [S0031-9007(96)
Multidrug resistance (MDR) remains one of the major reasons for inefficiency of many chemotherapeutic agents in cancer therapy. In this study, a D-α-tocopheryl polyethylene glycol 1000 succinate (TPGS) and polylysine-deoxycholic acid copolymer (PLL-DA) co-modified cationic liposome coating with hyaluronic acid (HA) was constructed for co-delivery of paclitaxel (PTX) and chemosensitizing agent, sorafenib (SOR) to treat the MDR cancer. The multifunctional liposome (HA-TPD-CL-PTX/SOR) presented good stability against rat plasma and was capable of reversing surface zeta potential under acidic conditions in the presence of HAase. Additionally, experimental result confirmed that the PLL-DA copolymer would facilitate the endo-lysosomal escape of the liposome. In vitro study demonstrated that HA-TPD-CL-PTX/SOR could significantly enhance drug accumulation in resistant MCF-7/MDR cells by inhibiting the P-gp efflux, and effectively inhibited growth of tumor cells. Furthermore, the liposome showed an enhanced anticancer activity in vivo, with a tumor growth inhibition rate of 78.52%. In summary, HA-TPD-CL-PTX/SOR exhibited a great potential for effective therapy of resistant cancers by combining with chemotherapeutic agents and could be a promising nano-carrier for reversing MDR and improving the effectiveness of chemotherapy.
Superconducting phases in La2Cu04+ & prepared at ambient temperature by electrochemical oxidation have been investigated for the nominal composition range 0(6'(0.1. Consistent with previous reports, a stable superconducting phase with T, -32-34 K is observed for 6~0.05. In contrast, samples with 8&0.05 are found to be unstable either at room temperature or upon annealing between 25 C and 110 C. All phases with
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.