No abstract

No abstract

A simple and efficient method is described to introduce structurally pre-determined mutations into recombinant genomes of filamentous phage M13. The method rests on gapped duplex DNA (gdDNA) molecules of the phage M13 genome as the key intermediate. In this gdDNA, the (+) and the (shorter) (-) strand carry different genetic markers in such a way, that a rigorous selection can be applied for phage carrying the markers of the (-) strand. For introduction of the mutation, a synthetic oligonucleotide with partial homology to a target site within the single stranded DNA region is annealed to the gdDNA. The oligonucleotide subsequently becomes part of the (-) strand by enzymatic DNA gap filling and sealing. This physical linkage is preserved at the genetic level after transfection of a recipient E.coli strain deficient in DNA mismatch correction, so that the synthetic marker can be selected from the phage progeny independent from its potential phenotype. It is demonstrated that by this method mutants can be constructed with marker yields in excess of 70%.

An efficient method for the construction of multiple mutations in a sequential manner is described. It is based on the gapped duplex DNA approach to oligonucleotide-directed mutagenesis (Kramer et al. 1984, Nucl. Acids Res. 12, 9441-9456) and a set of newly constructed phasmid vectors. These are characterized by the following features. Presence of the phage fl replication origin permits ready conversion to the single stranded DNA form. An amber mutation within, alternatively, the bla or cat gene provides a means for ready selection of the strand into which the mutagenic oligonucleotide has been incorporated. By means of the alternating antibiotic resistance markers any number of mutations can be constructed in consecutive rounds of mutagenesis. The optional presence of gene expression signals allows the direct overproduction of structurally altered proteins without re-cloning. Both the mutagenesis and expression aspects were tested using the lacZ gene as a model.

The helix-coil transitions of the 16 octadecameric DNA duplexes dCGTCGTTTXACAACGTCG X dCGACGTTGTX1AAACGACG with A, T, G, and C for X and X1 were measured by UV-absorption. This sequence was taken from former studies of in vivo determination of efficiencies of mismatch repair (Kramer, Kramer, and Fritz (1984) Cell 38, 879-887). The thermodynamic parameters for double strand and mismatch formation have been obtained by evaluating the partition function of a stack model which allowed for loop formation. As a result the mismatches could be classified into wobble base pairs (T/G, G/G, C/A, A/A, A/G), open base pairs, i.e. permanent loops (T/T, C/T, T/C, C/C), and intermediate or weak base pairs (G/T, A/C, G/A). There is no correlation between Tm and the biological repair efficiency of X/X1. The structure classes, however, as described above show a close correlation: Open base pairs show the lowest repair efficiencies, whereas mismatches with high repair efficiency always belong to the structural class of wobble base pairs. Because of the palindromic nearest neighbors of the variation site X/X1, the influence of next-nearest neighbor interactions could be detected and be estimated to about 1 kJ/mol for one stack.