The effect of various electrochemical pre-treatment methods on the surface and electrochemical properties of screen-printed carbon paste electrodes (SPCE) prepared with three different commercial products was examined. It was observed that a positively charged redox couple, e.g., hexaammineruthenium(III), exhibited quasi-reversible behavior at the untreated SPCE. However, the cyclic voltammograms (CVs) of the SPCE prepared with general-purpose carbon inks did not exhibit clear redox peaks to other representative redox couples [e.g., hexacyanoferrate(III), hexachloroiridate(IV), dopamine, and hydroquinone] without activation. Electrochemical pre-treatment methods were sought in four different aqueous solutions, i.e., sulfuric acid, potassium chloride, sodium hydrogencarbonate, and sodium carbonate, applying various activation potentials. It was found that the pre-treatment procedure in saturated Na2CO3 solution at 1.2 V provides a mild and effective condition for activating the SPCE. By measuring the water contact angles at the SPCE surfaces and recording their SEM images, it was confirmed that the electrochemical pre-treatment effectively removes the organic binders from the surface carbon particles. A prolonged period of activation (> 5 min) or the use of high potentials (> 1.2 V) increased the capacitance of the electrode over 20 microF cm(-2). The pre-treated SPCE behaved like a random array microelectrode, exhibiting a sigmoidal-shaped CV at a slow scan rate. The short pre-anodization method in Na2CO3 solution was generally applicable to most SPCE prepared with general-purpose carbon inks.

Potentiometric properties of the ion-selective electrodes) based on highly plasticized PVC membranes doped with the carbonate-selective cholic acid (CA) derivatives have been measured. The carbonate-selective neutral carriers have been prepared by coupling one to three trifluoroacetobenzoyl (TFAB) groups to a cholic acid derivative which has three hydroxyl linkers lining on the C3, C7, and C12 positions of its rigid steroidal ring structure. The membranes based on cholic acid derivatives with two TFABs [3,7-bis(TFAB)CA, 3,12-bis(TFAB)CA, and 7,12-bis(T-FAB)CA] exhibited remarkably improved carbonate selectivity, indicating that the bis(FAB)CAs behave like molecular tweezers for the carbonate ion. For example, 3,12-bis(TFAB)CA resulted in 10-300-fold-enhanced carbonate selectivity over other anions (e.g., salicylate, ClO4-, SCN-, (HPO4)2-, NO3-, NO2-, Br-, and Cl-) compared to that of the neutral carriers with a single TFAB group. The distances between the carbonate binding centers of bis(TFAB)CAs, i.e., the carbonyl carbons of the two TFAB groups, are in the 7.3-7.9-A range at the AM1 level semiempirical calculation, which is too far for the carbonate ion to form direct covalent bonding. The fast atom bombardment mass spectra of bis(TFAB)CAs show that significant fractions of the compounds are either mono- or dihydrated before complexing the carbonate ion. These findings seem to suggest that bis(TFAB)CAs recognize the incoming carbonate ion by forming both covalent and hydrogen bonding between the hydrated and unhydrated TFAB groups. The analytical utility of the carbonate-selective electrode based on 3,12-bis(TFAB)-CA has been demonstrated by measuring the total carbon dioxide in human serum in the presence of lipophilic anion interferents, e.g., salicylate.

We report a novel concept of sensing glycated hemoglobin, HbA 1c, which is now the most important index for a long-term average blood glucose level, by first selectively immobilizing it on the thiophene-3-boronic acid (T3BA) self-assembled monolayer (SAM)-covered gold electrode by a selective chemical reaction with boronic acid. HbA 1c thus immobilized is then detected by the label-free electrochemical impedance spectroscopic (EIS) measurements with a redox probe, an equimolar mixture of K 3Fe(CN) 6 and K 4Fe(CN) 6, present. The rate of charge transfer between the electrode and the redox probe is shown to be modulated by the amount of HbA 1c in the matrix hemoglobin solution due to the blocking effect caused by the binding of HbA 1c with boronic acid. Both the formation of a well-defined T3BA-SAM on the gold surface and the chemical binding of its boronic acid with HbA 1c in solution were confirmed by quartz crystal microbalance, atomic force microscopy, and EIS experiments.

No abstract