Non-uniform drying of rapid hardening overlays can lead to cracking and delamination. • Mixes with CSA cement showed much lower shrinkage strains than mixes with RSC cement. • RSC and FRSC mixes showed considerable autogenous shrinkage at the age of 60 days. • FE analysis were used to predict shrinkage development using hygral contraction coefficient. • Creep plays an important role in moderating stresses of overlays.

No abstract

This is a repository copy of Performance of rapid hardening recycled clean steel fibre materials.

No abstract

Wood, being renewable and highly abundant material, with excellent high specific strength and stiffness, has received increasing attention to be used in high performance applications such as the structural element of a battery case in an electric vehicle. For a successful implementation of wood in the automotive sector, it is, therefore, crucial to understand the behaviour of wood during and after temperature exposure and in the event of fire with the presence/absence of oxygen. In this study, the mechanical properties of thermally modified and unmodified European beech and birch in air and nitrogen environments at six different treatment intensities were characterised using compression tests, tensile tests, shear tests and Poisson’s ratio tests. Further, the elastic properties of these wood species were quantified using the ultrasound measurements. The obtained strength and stiffness exhibited mild improvement upon moderate temperature treatment (200 °C), followed by a decrease at elevated temperature levels. This improvement was somewhat more pronounced under nitrogen treatment than under air treatment conditions. Nevertheless, a more noticeable decrease in the material performance was observed in beech compared to birch, occurring at earlier stages of modifications. This study confirms the tension–compression asymmetry of beech and birch where higher Young’s moduli were obtained from tensile than from compression tests for reference and thermally treated beech and birch. The shear moduli obtained from ultrasound for birch were comparable to those obtained from quasi-static tests, whereas there was an overestimation of approximately 11–59% for the shear modulus of beech compared to quasi-static tests. Poisson’s ratios from ultrasound tests corresponded well with those from quasi-static tests for untreated beech and birch, but not for thermally modified samples. The Saint-Venant model can satisfactorily predict the shear moduli of untreated and treated beech wood.