No abstract

A three-dimensional numerical model has been developed to investigate the fluid flow and heat transfer behaviors in multilayer deposition of plasma arc welding (PAW) based wire and arc additive manufacture (WAAM). The volume of fluid (VOF) and porosity enthalpy methods are employed to track the molten pool free surface and solidification front, respectively. A modified double ellipsoidal heat source model is utilized to ensure constant arc heat input in calculation in the case that molten pool surface dynamically changes. Transient simulations were conducted for the 1 st , 2 nd and 21 st layer depositions. The shape and size of deposited bead and weld pool were predicted and compared with experimental results. The results show that for each layer of deposition the Marangoni force plays the most important role in affecting fluid flow, conduction is the dominant method of heat dissipation compared to convection and radiation to the air. As the layer number increases, the length and width of molten pool and the width of deposited bead increase, whilst the layer height decreases. However these dimensions remain constant when the deposited part is sufficiently high. In high layer deposition, where side support is absent, the depth of the molten pool at the rear part is almost flat in the Y direction. The profile of the deposited bead is mainly determined by static pressure caused by gravity and surface tension pressure, therefore the bead profile is nearly circular. The simulated profiles and size dimensions of deposited bead and molten pool were validated with experimental weld appearance, cross-sectional images and process camera images. The simulated results are in good agreement with experimental results.

No abstract

No abstract

Purpose -The purpose of this paper is to report a new direct metal manufacturing method which integrates freeform deposition process and micro rolling process, introduce the manufacturing principle and show the advantages of this method. Design/methodology/approach -This paper introduces the hybrid manufacturing principle and devices first. Then, the key parameters of hybrid manufacturing process are studied by contrast experiments. The results of comparisons of manufacturing accuracy, microstructure and tensile test between freeform fabricated parts and hybrid manufactured parts show the advantages of this new direct manufacturing method. Findings -The experiments results show that the accuracy of hybrid manufacturing method is improved obviously comparing with arc-based freeform deposition manufacturing method; the microstructure of the hybrid manufacturing part turns into cellular crystal instead of dendrite; the tensile strength of the part increases by 33 percent and the tensile deformation improved more than two times. Originality/value -The paper presents a new hybrid direct metal manufacturing method for the first time. The hybrid manufacturing devices are developed. The experiments results show that the hybrid manufacturing method can be used on directly fabricating large metal components with outstanding quality, efficiency and low cost. The application prospect is great.

No abstract

No abstract

This study shows that soft rock plays a key role in improving the WUE, NUE and FNUE of maize. © 2016 Society of Chemical Industry.