The demand for buildings constructed along subway lines is increasing, and analysis of the impact of foundation excavation and building construction on adjacent tunnels is critical. This study investigated the variation law of tunnel deformation and surrounding earth pressure on an existing tunnel resulting from deep foundation excavation and the load of buildings. Four groups of scale model tests and corresponding numerical simulation calculations were conducted in four different modes: over unloading-loading, shallow-side unloading-loading, middle-side unloading-loading, and deep-side unloading-loading, which are according to the different relative position of the foundation pit and the tunnel. The results show that when the tunnel stretches across different areas, corresponding deformation occurs owing to the different mechanical mechanisms during excavation and loading. The results can provide evidence for the further study on the impact of adjacent construction process on the tunnels.
Similar material model test and numerical simulation method were used to study the reinforcement effect of isolation piles on the existing shield tunnel structure in the adjacent building construction for analyzing foundation pit excavation and new building construction approaching existing shield tunnel engineering. The numerical simulation orthogonal experiment was used to optimize four isolation pile parameters. The conclusions were obtained as follows: (1) Isolation piles could share horizontal load of the soil at the rear side of the support structure and reduce horizontal displacement of the soil. As a result, maximum horizontal displacement of the tunnel structure and differences in horizontal displacement between the tunnel structure roof and the floor after foundation pit excavation and building loading were decreased. The horizontal displacement and torsional deformation of the tunnel structure toward the direction of the foundation pit were controlled, and the increase in internal forces of the transverse tunnel structure was also restrained. (2) At the elevation above the tunnel roof, the increase in burial depth of the isolation pile top slightly affected the reinforcement effect on the tunnel structure. The increase in burial depth of the isolation pile bottom could improve the reinforcement effect. Thus, burial depth of the isolation pile bottom should be properly increased in the engineering practice. The reduction in pile spacing could improve the reinforcement effect. Accordingly, pile spacing should be properly selected in the engineering practice. With the increase of diameter of the isolation pile, the reinforcement effect of isolation piles increased obviously. (3) Pile diameter had the greatest influence on the reinforcement effect of isolation piles, followed by burial depth of the pile bottom, pile spacing, and burial depth of the pile top. Orthogonal experiments indicated the following optimal parameter values: a pile diameter of 1.2 m, a burial depth of the pile bottom of 2H, a pile spacing of 1.6 m, and a burial depth of the pile top of 0.75Z.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.