Free-floating, and copper-supported, few-layer graphene sheets were spontaneously modified from an aqueous solution containing nitrobenzenediazonium ions. The infrared spectra of the chemically modified (copper etched) free-floating graphene were measured in transmission mode by manipulating the sheets onto a KBr disc. The major advantage to this method is the ability to release the graphene sheets off the disc to refloat on a water bath, allowing the graphene to be further modified or deposited onto a new substrate suitable for other analysis. In this study, graphene sheets were then mounted onto highly ordered pyrolytic graphite (HOPG) for atomic force microscopy imaging and electrochemical measurements. The results show there are at least two reaction pathways for spontaneous film grafting to graphene: the commonly accepted aryl radical leading to films containing −C−C− linkages and a direct reaction of the diazonium cation with graphene to give films containing −NN− linkages. The ability to manipulate modified graphene sheets onto electrodes with two orientations, with the film exposed to electrolyte solution or sandwiched between graphene and HOPG, leads to different estimates of the surface concentration of electroactive groups. When the film is sandwiched between graphene and HOPG, two electroreduction signals for the nitro group are seen and much larger surface concentrations are measured. This is the first account of such a signal and is tentatively attributed to different peak potentials for reduction of nitro groups at graphene and HOPG. The solution permeability through the graphene sheet and attached films has important electrochemical consequences for systems of this type employed in supercapacitor applications.

The quantum capacitance from large area, 6- to 7-layered graphene, and chemically modified graphene, was determined using electrochemical impedance spectroscopy measured at 100 Hz in a three-electrode electrochemical cell and aqueous acidic solution. Aryldiazonium chemistry was used to modify one side of the few-layered graphene sheets with methoxy- and iodo-phenyl groups. The graphene sheets were then mounted via an aqueous transfer method onto an epoxy substrate. It was found that both sides of the graphene sheets could be accessed by the electrolyte and thus the sheets were in a pseudo free-floating arrangement. The results show a complex quantum capacitance behavior with applied electrode potential, and that behavior was not stable with potential cycling. Chemically modified samples have similar quantum capacitance minimum to unmodified graphene, and all samples have a shallow U-shaped relationship with respect to applied electrode potential. The results show chemically modifying one side of few-layer graphene sheets using diazonium chemistry was not detrimental to the measured quantum capacitance minimum at the potential of zero charge, but the capacitance remained low over a large potential window which is not desirable for supercapacitor applications.

Methods that reliably yield monolayers of covalently anchored modifiers on graphene and other planar graphitic materials are in demand. Covalently bonded groups can add functionality to graphitic carbon for applications ranging from sensing to supercapacitors and can tune the electronic and optical properties of graphene. Limiting modification to a monolayer gives a layer with well-defined concentration and thickness providing a minimum barrier to charge transfer. Here we investigate the use of anthranilic acid derivatives for grafting aryl groups to few layer graphene and pyrolyzed photoresist film (PPF). Under mild conditions, anthranilic acids generate arynes, which undergo Diels-Alder cycloadditions. Using spectroscopy, electrochemistry, and atomic force microscopy, we demonstrate that the reaction yields monolayers of aryl groups on graphene and PPF with maximum surface coverages consistent with densely packed layers. Our study confirms that anthranilic acids offer a convenient route to covalent modification of planar graphitic carbons (both basal and edge plane materials).

The interaction between nanoparticle plasmonic states and molecular electronic states is central to the large enhancements observed in surface‐enhanced Raman scattering (SERS). In this work, we use a model previously used in a fully quantum mechanical description of SERS to explain the enhancement of nontotally symmetric modes for crystal violet (CV) and malachite green (MG) adsorbed on silver nanoparticles. Our explanation is consistent with recent observations of the absorption spectra of dyes on silver nanoparticles that show the absence of charge‐transfer in these systems. Resonance with plasmon and molecular states explains the enhancement of nontotally symmetric modes, with enhancement dominated by the plasmon states. Spectroelectrochemical SERS studies using the same silver nanoparticles that are used to generate SERS in solution show increased SERS intensity for CV with positive potential up to +0.4 V (vs Ag/AgCl), consistent with a red‐shifted plasmon resonance, and decreasing intensity with more positive potentials, consistent with oxidation of the silver nanoparticles. Both crystal violet and malachite green show similar spectroelectrochemical behaviour with 514.5 nm excitation. Our spectroelectrochemical data show that SERS intensities from silver nanoparticles can be optimised with appropriately applied potentials. This work has highlighted the need for more detailed studies of the spectroelectrochemistry of dyes adsorbed on silver nanoparticles to more fully understand how SERS intensities respond to applied potentials. Copyright © 2016 John Wiley & Sons, Ltd.