The interpretation of seismic anisotropy in Earth's upper mantle has traditionally been based on the fabrics (lattice-preferred orientation) of relatively water-poor olivine. Here we show that when a large amount of water is added to olivine, the relation between flow geometry and seismic anisotropy undergoes marked changes. Some of the puzzling observations of seismic anisotropy in the upper mantle, including the anomalous anisotropy in the central Pacific and the complicated anisotropy in subduction zones, can be attributed to the enrichment of water in these regions.

Seismic anisotropy is caused mainly by the lattice-preferred orientation of anisotropic minerals. Major breakthroughs have occurred in the study of lattice-preferred orientation in olivine during the past ∼10 years through large-strain, shear deformation experiments at high pressures. The role of water as well as stress, temperature, pressure, and partial melting has been addressed. The influence of water is large, and new results require major modifications to the geodynamic interpretation of seismic anisotropy in tectonically active regions such as subduction zones, asthenosphere, and plumes. The main effect of partial melting on deformation fabrics is through the redistribution of water, not through a change in deformation geometry. A combination of new experimental results with seismological observations provides new insights into the distribution of water associated with plume-asthenosphere interactions, formation of the oceanic lithosphere, and subduction. However, large uncertainties remain regarding the role of pressure and the deformation fabrics at low stress conditions. 59

No abstract

No abstract

No abstract

A new type of olivine fabric was found by high-strain simple-shear deformation experiments in the presence of trace amounts of water at ϳ0.5-2.2 GPa and ϳ1470-1570 K. In this fabric, called E-type fabric, the olivine [100] axis is subparallel to the shear direction, and the (001) plane is parallel to the shear plane; this geometry suggests that the [100](001) slip system makes the dominant contribution to total strain. This fabric is dominant at a modest water content, 200 Ͻ C OH Ͻ 1000 H/10 6 Si at low stresses and high temperatures. Some mylonites from peridotite massifs show this type of olivine fabric, which suggests the presence of water during the shear localization. The seismic anisotropy caused by this fabric is qualitatively similar to that by dry fabric (A type), but the magnitudes of anisotropy are different between the two types: for horizontal flow, the amplitude of V SH /V SV anisotropy is weaker, but the amplitude of shear-wave splitting is stronger for the E-type fabric than for the A-type dry fabric. Seismic anisotropy in the oceanic upper mantle may be due to the olivine E-type fabric.

Earthquakes are observed to occur in subduction zones to depths of approximately 680 km, even though unassisted brittle failure is inhibited at depths greater than about 50 km, owing to the high pressures and temperatures. It is thought that such earthquakes (particularly those at intermediate depths of 50-300 km) may instead be triggered by embrittlement accompanying dehydration of hydrous minerals, principally serpentine. A problem with failure by serpentine dehydration is that the volume change accompanying dehydration becomes negative at pressures of 2-4 GPa (60-120 km depth), above which brittle fracture mechanics predicts that the instability should be quenched. Here we show that dehydration of antigorite serpentinite under stress results in faults delineated by ultrafine-grained solid reaction products formed during dehydration. This phenomenon was observed under all conditions tested (pressures of 1-6 GPa; temperatures of 650-820 degrees C), independent of the sign of the volume change of reaction. Although this result contradicts expectations from fracture mechanics, it can be explained by separation of fluid from solid residue before and during faulting, a hypothesis supported by our observations. These observations confirm that dehydration embrittlement is a viable mechanism for nucleating earthquakes independent of depth, as long as there are hydrous minerals breaking down under a differential stress.

Aluminum nitride (AlN) is an appealing nonlinear optical material for on-chip wavelength conversion. Here we report optical frequency comb generation from high-quality-factor AlN microring resonators integrated on silicon substrates. By engineering the waveguide structure to achieve near-zero dispersion at telecommunication wavelengths and optimizing the phase matching for four-wave mixing, frequency combs are generated with a single-wavelength continuous-wave pump laser. Further, the Kerr coefficient (n₂) of AlN is extracted from our experimental results.