Agricultural residues, such as lignocellulosic materials (LM), are the most attractive renewable bioenergy sources and are abundantly found in nature. Anaerobic digestion has been extensively studied for the effective utilization of LM for biogas production. Experimental investigation of physiochemical changes that occur during pretreatment is needed for developing mechanistic and effective models that can be employed for the rational design of pretreatment processes. Various-cutting edge pretreatment technologies (physical, chemical and biological) are being tested on the pilot scale. These different pretreatment methods are widely described in this paper, among them, microaerobic pretreatment (MP) has gained attention as a potential pretreatment method for the degradation of LM, which just requires a limited amount of oxygen (or air) supplied directly during the pretreatment step. MP involves microbial communities under mild conditions (temperature and pressure), uses fewer enzymes and less energy for methane production, and is probably the most promising and environmentally friendly technique in the long run. Moreover, it is technically and economically feasible to use microorganisms instead of expensive chemicals, biological enzymes or mechanical equipment. The information provided in this paper, will endow readers with the background knowledge necessary for finding a promising solution to methane production.

No abstract

No abstract

China produces large amount of cotton stalk (CS) residues as agricultural biomass, which are incinerated on-site, causing air pollution. The high organic content of CS could be utilized for biogas production, but the direct digestion without pretreatment always leads to a low methane yield and biodegradability, due to the complicated structure of lignocellulose. In order to search best fitting pretreatment methods in effective anaerobic digestion (AD) of CS, effects of various pretreatments including KOH, NaOH, Ca(OH)2, alkali hydrogen peroxide (AHP), H2SO4, H3PO4 and steam explosion (SE) were studied. It was seen that all treatments resulted in varying methane yields. Among all the pretreatments, acid pretreatment is not suitable for AD of CS. The results showed that the highest cumulative methane yield (CMY) of 192.4 mL·gVS−1 was obtained after 3% AHP pretreatment of CS, and the methane yield improved by 254.3% than the untreated CS. Therefore, AHP treatment was proven to be an efficient pretreatment technique. XRD and FTIR analyses had shown that pretreated CS had favorable structural changes. This research is beneficial in developing environment friendly and cost-effective pretreatment technologies to utilize CS for methane production in future application.

Graphical abstract