To realize a compact spherical tokamak (ST) reactor, operation without the central solenoid (CS) must be demonstrated. In particular plasma current (I p) ramp-up from zero to a level required for fusion burn is crucial. Plasma initiation and I p ramp-up in ST by waves in the lower-hybrid (LH) frequency range were demonstrated for the first time on TST-2. A combline antenna was used to inject RF power of ~ 100 kW at 200 MHz. Formation of a low current (~ 1kA, mainly driven by pressure gradient) ST configuration can be accomplished by waves over a broad frequency range (21 MHz to 8.2 GHz in TST-2), but further I p ramp-up (to ~ 10 kA, mainly driven by RF) is most efficient with uni-directional traveling waves in the LH frequency range. I p ramp-up to 15 kA was achieved with 60 kW of net RF power. Soft X-ray emission in the direction of electron acceleration by RF wave was enhanced more strongly in the co-drive case (acceleration in the direction to increase I p) compared to the counter-drive case. Hard X-ray spectral measurements showed that the photon flux is an order of magnitude higher and the photon temperature is higher in the co-current-drive direction than in the counter-current-drive direction. These observations are consistent with acceleration of electrons by a unidirectional RF wave. The combline antenna excites vertical electric fields which match the polarization of the fast wave (FW). There is evidence that the LH wave (or the slow wave, SW) is excited nonlinearly, based on the frequency spectra measured by magnetic probes in the plasma edge region. The time evolution indicates the tendency of the pump wave to weaken when the sideband waves intensify. It is expected that the effectiveness of current drive would improve if the LH wave could be excited directly by the antenna. Two types of travelingwave LH antennas will be tested on TST-2, a dielectric-loaded waveguide array ("grill") antenna, and an array of capacitively coupled elements with the electric field polarized in the toroidal direction. During initial operation of the grill antenna, wavenumber components were measured by an array of magnetic probes. Results were qualitatively consistent with expectations based on dispersion relations for the FW and the SW.

AC Ohmic coil operation experiments with frequencies up to 10 kHz were performed on the TST-2 spherical tokamak device, and the pre-ionization process was studied in detail. The minimum loop voltage for pre-ionization was 0.4 V, which corresponds to 0.5 V m −1 at the inboard limiter. Dependences of growth rate and saturation level of the process on various parameters were obtained, and they are compared with a time-dependent 0-dimensional model based on Townsend avalanche and loss along field lines. Most of the dependences are reproduced qualitatively by the model, and quantitative differences are within a factor of several. However, the external vertical field dependence of the appearance time, which is defined as the time to observe a plasma, and the isotope effect cannot be reproduced by the model. An ambipolar diffusion state which is predicted theoretically but mitigated experimentally is discussed. It was found that secondary electron emission at the limiter surfaces is a candidate mechanism to mitigate the state.

Non-inductive plasma current start-up experiments were performed using the lower hybrid wave (LHW) on the TST-2 spherical tokamak. The density limit, observed in previous experiments using the outboard-launch antenna, disappeared after changing the plasma condition in the scrape-off layer, and the plasma current reached about 20 kA. In order to improve the LHW power deposition in the plasma core through an up-shift of the parallel wavenumber during the first pass through the plasma, a new top-launch antenna was designed, fabricated and installed. The plasma current ramp-up to 12 kA was achieved using the top-launch antenna alone in a preliminary experiment. Ray-tracing calculations using the measured plasma parameters showed a large up-shift during the first pass, satisfying the strong electron Landau damping condition in the plasma core.

Noninductive plasma startup is a critical issue for spherical tokamaks since there is not enough room to provide neutron shielding for the center solenoid. Startup using lower hybrid (LH) waves has been studied on the TST2 spherical tokamak. Because of the low magnetic field of a spherical tokamak, the plasma density needs to be kept at a very low value during the plasma current rampup so that the plasma core remains accessible to the LH waves. However, we have found that higher density was required to sustain larger plasma current. The achievable plasma current was limited by the maximum operational toroidal field of TST2. The existence of an optimum density for LH current drive and its toroidal field dependence is explained through a numerical simulation based on a ray tracing code and a Fokker-Planck solver. In order to access higher density at the same magnetic field, a toplaunch antenna was recently installed in addition to the existing outboardlaunch antenna. Increase in the density limit was observed when the power was launched from the top antenna, consistently with the numerical predictions.

Non-inductive plasma current start-up and sustainment by waves in the lower-hybrid frequency range (200 MHz) have been studied on the TST-2 spherical tokamak (R 0 0.38 m, a 0.25 m, B t0 0.3 T, I p 0.14 MA) using three types of antenna: the 11-element inductively-coupled combline antenna, the dielectric loaded 4-waveguide array antenna, and the 13-element capacitively-coupled combline (CCC) antenna. The maximum plasma currents of 15 kA, 10 kA and 16 kA were achieved, respectively. The highest current drive figure of merit η CD ≡ n e I p R/P RF was achieved by the CCC antenna. The efficiency of current drive should improve by reducing prompt orbit losses of high energy electrons by operating at higher plasma current (to improve orbit confinement) and higher toroidal magnetic field (to improve wave accessibility to the plasma core), while keeping the density high enough (to avoid excessive acceleration of electrons), but under the 'density limit'.