We have demonstrated efficient coupling of 0.35 p, m laser light for radiation production in inertial confinement fusion (ICF) cavity targets. Temperatures of 270 eV are measured in cavities used for implosions and 300 eV in smaller cavities, significantly extending the temperature range attained in the laboratory to those required for high-gain indirect drive ICF. High-contrast, shaped drive pulses required for implosion experiments have also been demonstrated for the first time. Low levels of scattered light and fast electrons are observed, indicating that plasma instability production is not significant.PACS numbers: 52.50.Jm, 52.40.Nk, 52.70.La Inertial confinement fusion (ICF) uses high powered laser or particle beams to compress and heat capsules containing fusion fuel with the goal of producing thermonuclear energy [1,2]. One proposed method for ICF is x-ray drive where high powered beams heat high-Z cavities, or Hohlraums, converting the driver energy to x rays which implode the capsule [3]. Present indirect drive target designs predict ignition, and gain can be attained with a 1-2 MJ laser for radiation drive temperatures on the order of 300 eV [4]. In this Letter we report experiments using the Nova laser that demonstrate efficient cavity heating with 0.35 p, m light to the temperatures required for these ignition target designs. Radiation temperatures in excess of 270 eV have been obtained in cavities used for implosions [5], while 300 eV temperatures have been obtained in smaller cavities. These radiation cavities are the highest thermal sources measured in the laboratory. The temperature scaling is consistent with a simple power balance model successfully used to model previous experiments at lower temperatures [6,7], extending its proven range of validity. We have demonstrated that shaped radiation drive pulses required to control shock preheat can easily be attained by varying the incident laser power. Laserplasma instabilities [8] that could reduce coupling efficiency and produce superthermal electrons appear not to be significant. Fast electrons are low, typically less than a few percent, indicating superthermal electron preheat is small. In addition to high density implosion experiments [9,10], these cavities have been used for a variety of radiation heating experiments including hydrodynamic instability studies of radiatively accelerated material both in planar [11,12] and convergent systems [13] and opacity experiments of radiatively heated material [14].

We have made absolute measurements of x-ray spectra from 0.1–1.5 keV produced by plasmas from targets irradiated by the Lawrence Livermore National Laboratory Nova laser. These measurements were made using a 15-channel K- and L-edge filtered x-ray diode system. Valid interpretation of the results from this type of diagnostic requires some care in eliminating the effect of channel response at photon energies higher than the absorption edge. Significant errors can occur if this is disregarded. We will discuss the techniques used and the magnitude of the effects observed. Integrated x-ray energy in the 1.5–3-keV region is inferred from the results.

Nearly 10 years of Nova [E. M. Campbell, Laser Part. Beams 9, 209 (1991)] experiments and analysis have lead to a relatively detailed quantitative and qualitative understanding of radiation drive in laser-heated hohlraums. Our most successful quantitative modeling tool is two-dimensional (2-D) LASNEX numerical simulations [G. B. Zimmerman and W. L. Kruer, Comments Plasma Phys. Controlled Fusion 2, 51 (1975)]. Analysis of the simulations provides us with insight into the physics of hohlraum drive. In particular we find hohlraum radiation conversion efficiency becomes quite high with longer pulses as the accumulated, high-Z blow-off plasma begins to radiate. Extensive Nova experiments corroborate our quantitative and qualitative understanding.