A recently developed in situ testing method, called the sharp cone test, which is in fact a continuous and automated version of the pressuremeter test, consists of pushing a low-angle truncated cone into a smaller diameter prebored or self-bored pilot hole. As the cone descends, it causes a continuous enlargement of the pilot hole, which, with proper instrumentation, can be translated into a relationship between radial pressure and radial (or shear) strain, similar to the expansion curve of a pressuremeter test. The present paper describes the use in the field of two new versions of this instrument: the first one with 2°taper, having on its lateral surface four total pressure transducers and a pore pressure transducer; and the second one with two successive taper angles of 1°and 2°, having five total pressure transducers installed at various distances from the tip. The latter probe was found to be capable of continuously furnishing five points on a pressure-expansion curve, which can be translated into a stress-strain relationship by using conventional pressuremeter data-processing procedures. The first probe, in turn, was used for simultaneously observing the decrease with time of both total lateral pressure and pore pressure during strain-holding periods of the test. In 2002, the two newly designed instruments were tested in a thick layer of saturated clay at a site near Montréal. A comparison of the results with those obtained at the same site by some other types of tests is very encouraging.Résumé : Une nouvelle méthode pour la mesure in situ des propriétés mécaniques des sols, appelée « Essai au cône effilé », consiste à pousser dans un trou pilote de plus faible diamètre, pré-foré ou auto-foré, une sonde cylindrique, légèrement effilée. En descendant, cette sonde élargit le trou d'une façon continue, ce qui, avec une instrumentation appropriée installée à sa surface latérale, peut se traduire en une relation entre la pression et la déformation radiale, tel que dans un essai pressiométrique. Dans cet article on présente l'utilisation de deux nouvelles versions de cette sonde: La première avec l'angle d'effilement de 2°, munie de quatre capteurs de pression latérale totale et d'un capteur de pression interstitielle, et la seconde, avec deux angle d'effilement successifs de 1°et 2°, munie de cinq capteurs de pression latérale totale. Cette deuxième sonde s'est avérée capable de fournir, d'une façon continue et en toute profondeur, cinq points d'une courbe quasi-pressiométrique, d'où un nombre illimité des courbes contraintes-déformations peut être déduit. La deuxième sonde, a pour sa part, servi à observer la chute des pressions totales et interstitielles lors des périodes d'arrêt de la sonde. Tous ces essais ont été effectués en 2002 sur un site près de Montréal, contenant une couche épaisse d'argile saturée. La comparaison de ces résultats avec ceux de quelques autres types d'essais, s'est avérée très encourageante.Mots clés : essais in situ, argile, cône effilé, pressiomètre, à court terme, à long terme.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.