A thermomechanical finite-element model of flat rolling is coupled with closed form equations describing the process of recrystallization and is applied to study hot rolling of low carbon steel strips. Formulae for the recrystallized grain diameters, developed by various authors, are considered. Calculated diameters of the grains are compared with the results of the measurements carried out after experimental hot rolling of the carbon steel samples. Evaluatingthe accuracy of the calculations. using each of the expressionsfor the diameter of the recrystallized austenite grains, indicates that the relation of Roberts is closest to the measurements. Ausbildung der Mikrostruktur beim Warmwalzen. Ein thermomechanisches Finite-Elemente-Modell, das beim Flachwalzen bekannt lst, wird mit analytischen Gleichungen, die die Rekristallisation beschreiben, gekoppelt. Das resultierende System soli Aussagen Ober das GefOge nach dem Warmwalzen von kohlenstoffarmem Bandstahl zulassen, Beziehungen fOr die Korndurchmesser nach Rekristallisation von verschiedenen Autoren werden diskutiert. Die berechneten Korndurchmesser werden mit Werten verglichen, die an warmgewalzten Stahlproben gemessenwurden. Die Auswertung der Genauigkeit dieser Rechenmodelle zeigt, daB die Beziehung von Roberts die Verhaltnisse am besten wiedergibt.
The paper deals with the problem of the prediction of the microstructure evolution during the hot deformation of carbon-manganese steels. Theobjective of the work is the validation of the approach which incorporates an advanced thermal-mechanical
This paper focuses on the problem of the evaluation of strains around the inclusions of various shapes and properties located in the uniform matrix undergoing large plastic deformations. The analysis is performed using the rigid-plastic finite-element approach. The uniform plane-strain deformation field is simulated by an introduction of zero friction forces into the program for the compression process. An assumption that the die is wider than the sample allows to simulate ideally uniform flow of metal. Several shapes of the inclusions are investigated, but the results for three most common shapes of the particle's cross-section are presented in the paper. They are: square with the sides parallel to the main directions, square with the sides inclined under an angle of 45°to the main directions and round. Formanderungsfelder um Einschliisse einer anderen Phase in einer gleichmaBigen Matrix unter plastischer Umformung. Diese Arbeit behandelt das Problem der Formanderungen lrn Bereich von EinschlOssen mit unterschiedlicher Form und Eigenschaften, die sich in einer einheitlichen Matrix befinden und groBen plastischen Umformungen ausgesetzt sind. Die Analyse wird mit dem starr-plastischen Finite-Element-Ansatz durchgefOhrt. Das einheitliche Umformfeld bei ebener Formanderung wird simuliert, indem die Reibungskraft im Programm fOr den Druck gleich Null gesetzt wird. Unter der Voraussetzung, daB der Stempel breiter als die Probe ist, kann ideales FlieBen simuliert werden. Verschiedene EinschluBformen werden untersucht, aber nur die Ergebnisse fOr die drei am hauflqsten auftretenden Querschnittsformen (Quadrat, Raute, Rund) werden hier angegeben.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.