Friction stir welding (FSW) experiments with different panel dimensions and welding parameters have been designed to study the distortion of FSW. The FSW experiments were carried out with a load control facility to make the welding parameters reliable. The distortion of FSW is much smaller than that of arc welding, but it is still very significant. Three-dimensional distortion measuring system was applied to further study distortion trends. The results show that the distortion after FSW is in saddle shape, with convex bending in longitudinal direction and concave bending in transverse direction. This distortion pattern is in contrary with that of traditional arc welding. It is also found that increasing the panel length increases the longitudinal distortion but almost do not influence the transverse distortion. Increasing the rotation speed increases both longitudinal distortion and transverse distortion. The influence of welding speed on distortion is not very clear.
Yield stress of 6013-T6 aluminium alloy was tested on Gleeble 1500D thermal-mechanical system at predesigned temperatures during different typical thermal cycles, in order to accurately reflect the influence of weld thermal history on material properties. The typical thermal cycles were referred to the temperature field simulation results of real welding process. The changes of yield stress were obtained directly from the stress-strain curves generated by the tensile tests. The tests were more accurate than previous publications, where only the yield stresses at room temperature after thermal history were tested or calculated from microstructure evolution model. Experimental results showed that the changes of yield stress during the cooling stage of typical thermal cycles followed one set of curves. These yield stress-temperature curves were different from those during the heating stage. Temperature and temperature history dependent material model M2 and M3 were established based on the experimental results. M2 model was perfectly plastic model while work hardening effect was considered in M3 model. Compared with conventional temperature dependent material model M1, the distributions of longitudinal residual stress and strain obtained with temperature and temperature history dependent models fit better with published results. Yield stress of the material at the weld zone decreased a lot after having experienced weld thermal history and longitudinal compressive plastic strain at the weld zone recovered to some extent during the cooling stage in M2 and M3 models. These were the main causes for lower peak longitudinal residual tensile stress in M2 and M3 models.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.