We measure the current vs voltage (I-V) characteristics of a diodelike tunnel junction consisting of a sharp metallic tip placed at a variable distance d from a planar collector and emitting electrons via electric-field assisted emission. All curves collapse onto one single graph when I is plotted as a function of the single scaling variable Vd^{-\lambda}, d being varied from a few mm to a few nm, i.e., by about six orders of magnitude. We provide an argument that finds the exponent {\lambda} within the singular behavior inherent to the electrostatics of a sharp tip. A simulation of the tunneling barrier for a realistic tip reproduces both the scaling behavior and the small but significant deviations from scaling observed experimentally.Comment: 6 pages, 6 figures. Accepted for publication in Physical Review

We perform scanning tunnelling microscopy (STM) in a regime where primary electrons are field-emitted from the tip and excite secondary electrons out of the target—the scanning field-emission microscopy regime (SFM). In the SFM mode, a secondary-electron contrast as high as 30% is observed when imaging a monoatomic step between a clean W(110)- and an Fe-covered W(110)-terrace. This is a figure of contrast comparable to STM. The apparent width of the monoatomic step attains the 1 nm mark, i.e. it is only marginally worse than the corresponding width observed in STM. The origin of the unexpected strong contrast in SFM is the material dependence of the secondary-electron yield and not the dependence of the transported current on the tip–target distance, typical of STM: accordingly, we expect that a technology combining STM and SFM will highlight complementary aspects of a surface while simultaneously making electrons, selected with nanometre spatial precision, available to a macroscopic environment for further processing.

The current flowing through a Mott spin junction depends on the relative spin orientation of the two ferromagnetic layers comprising the “source” and “drain” sides of the junction. The resulting current asymmetry is detected as giant or tunnelling magnetoresistance depending on whether the two ferromagnets are separated by a metal or an insulator. Based on the fundamental principles of reciprocity for spin-dependent electron scattering, one can envisage a one-magnet-only spin junction in which the source is non-magnetic, and the spin information is encoded by the spin polarisation of the electrons that have crossed or are backscattered from the drain magnetic layer. The practical significance of using an unpolarised source is that the state of the magnetic layer can be modified without affecting the process of probing it. Whether this reciprocity is realised in the actual junctions is not yet known. Here, we demonstrate a nano-sized, one-magnet-only Mott spin junction by measuring the finite spin polarisation of the backscattered electrons. Based on this finding, we conclude that since the junction acts as a spin filter, the magnetic layer must experience a spin transfer that could become detectable in view of the high current densities achievable in this technology.

No abstract

To optimise the design of the light readout in the ArDM 1-ton liquid argon dark matter detector, a range of reflector and WLS coating combinations were investigated in several small setups, where argon scintillation light was generated by radioactive sources in gas at normal temperature and pressure and shifted into the blue region by tetraphenyl butadiene (TPB). Various thicknesses of TPB were deposited by spraying and vacuum evaporation onto specular 3MTM-foil and diffuse Tetratex® (TTX) substrates. Light yields of each reflector and TPB coating combination were compared. Reflection coefficients of TPB coated reflectors were independently measured using a spectroradiometer in a wavelength range between 200 and 650 nm. WLS coating on the PMT window was also studied. These measurements were used to define the parameters of the light reflectors of the ArDM experiment. Fifteen large 120 × 25 cm2 TTX sheets were coated and assembled in the detector. Measurements in argon gas are reported providing good evidence of fulfilling the light collection requirements of the experiment.