No abstract

No abstract

In order to improve the static start-up problem of Savonius wind turbines, a Savonius wind turbine with a modified blade is proposed. It was obtained by twisting the half-cylindrical blades of the basic Savonius wind turbine by 70°. The aerodynamic performance of the wind turbine before and after the modification was compared. Firstly, the static torque coefficient of two wind turbines at different azimuth angles were obtained by means of three-dimensional numerical simulation. The static flow field around the wind turbine was analyzed. Then, the output power and speed characteristics of a spiral Savonius wind turbine under different incoming wind speeds were evaluated in the wind tunnel. The results show that, compared with the Savonius wind turbine with half-cylindrical blades, the spiral wind turbine could start at any azimuths in one rotation cycle. The reverse torque was eliminated. The static torque coefficient fluctuation range was reduced by 10%. The start-up performance was effectively improved. This investigation could provide guidance for the improvement of start-up characteristics of Savonius wind turbines.

In order to get rid of the impact of the global financial crisis and actively respond to global climate change, it has become a common choice for global economic development to develop clean energy such as wind energy, improve energy efficiency and reduce greenhouse gas emissions. With the advantages of simple structure, unnecessary facing the wind direction, and unique appearance, the vertical axis wind turbine (VAWT) attracts extensive attention in the field of small and medium wind turbines. The lift-type VAWT exhibits outstanding aerodynamic characteristics at a high tip speed ratio, while the starting characteristics are generally undesirable at a low wind speed; thus, how to improve the starting characteristics of the lift-type VAWT has always been an important issue. In this paper, a lift-drag combined starter (LDCS) suitable for lift-type VAWT was proposed to optimize the starting characteristics of lift-type VAWT. With semi-elliptical drag blades and lift blades equipped on the middle and rear part outside the starter, the structure is characterized by lift-drag combination, weakening the adverse effect of the starter with semi-elliptical drag blades alone on the output performance of the original lift-type VAWT and improving the characteristics of the lift-drag combined VAWT. The static characteristic is one of the important starting characteristics of the wind turbine. The rapid development of computational fluid dynamics has laid a solid material foundation for VAWT. Thus the static characteristics of the LDCS with different numbers of blades were investigated by conducting numerical simulation and wind tunnel tests. The results demonstrated that the static torque coefficient of LDCS increased significantly with the increased incoming wind speed. The average value of the static torque coefficient also increased significantly. This study can provide guidelines for the research of lift-drag combined wind turbines.

This paper describes the method of preparing strong hydrophobic polypyrrole (PPy) on wind turbine blades. The water contact angle of strong hydrophobic PPy coatings was 127.2°. The strong hydrophobic PPy coatings exhibited excellent anti-icing properties. The maximum icing weight of strong hydrophobic PPy coating blade was almost 0.10 g while the maximum icing weight of no coating blade was found to be 26.13 g. The maximum icing thickness of a strong hydrophobic PPy coating blade was only 1.08 mm. The current research will provide a better technique to create anti-icing coatings on wind turbine blades and other outdoor equipment.