Wireless body area networks (WBANs) offer many promising new applications in the area of remote health monitoring. An important element in the development of a WBAN is the characterization of the physical layer of the network, including an estimation of the delay spread and the path loss between two nodes on the body. This paper discusses the propagation channel between two half-wavelength dipoles at 2.45 GHz, placed near a human body and presents an application for cross-layer design in order to optimize the energy consumption of different topologies. Propagation measurements are performed on real humans in a multipath environment, considering different parts of the body separately. In addition, path loss has been numerically investigated with an anatomically correct model of the human body in free space using a 3-D electromagnetic solver. Path loss parameters and time-domain channel characteristics are extracted from the measurement and simulation data. A semi-empirical path loss model is presented for an antenna height above the body of 5 mm and antenna separations from 5 cm up to 40 cm. A time-domain analysis is performed and models are presented for the mean excess delay and the delay spread. As a cross-layer application, the proposed path loss models are used to evaluate the energy efficiency of single-hop and multihop network topologies.
In vitro dielectric properties of ageing porcine tissues were measured in the frequency range of 50 MHz-20 GHz, and the total combined uncertainties of the measurements were assessed. The results show statistically significant reduction with age in both permittivity and conductivity of 10 out of 15 measured tissues. At microwave frequencies, the observed variations are mainly due to the reduction in the water content of tissues as an animal ages. The results obtained were then used to calculate the SAR values in children of age 3 and 7 years when they are exposed to RF induced by walkie-talkie devices. No significant differences between the SAR values for the children of either age or for adults were observed.
Abstract-We present a flexible folded slot dipole implantable antenna operating in the Industrial, Scientific, and Medical (ISM) band (2.4-2.4835 GHz) for biomedical applications. To make the designed antenna suitable for implantation, it is embedded in biocompatible Polydimethylsiloxane (PDMS). The antenna was tested by immersing it in a phantom liquid, imitating the electrical properties of the human muscle tissue. A study of the sensitivity of the antenna performance as a function of the dielectric parameters of the environment in which it is immersed was performed. Simulations and measurements in planar and bent state demonstrate that the antenna covers the complete ISM band. In addition, Specific Absorption Rate (SAR) measurements indicate that the antenna meets the required safety regulations.Index Terms-Implantable antennas, Industrial, Scientific and Medical (ISM) band, Specific Absorption Rate (SAR), bent antenna, muscle tissue sensitivity.
In this paper, personal electromagnetic field exposure of the general public due to 12 different radiofrequency sources is characterized. Twenty-eight different realistic exposure scenarios based upon time, environment, activity, and location have been defined and a relevant number of measurements were performed with a personal exposure meter. Indoor exposure in office environments can be higher than outdoor exposure: 95th percentiles of field values due to WiFi ranged from 0.36 to 0.58 V m(-1), and for DECT values of 0.33 V m(-1) were measured. The downlink signals of GSM and DCS caused the highest outdoor exposures up to 0.52 V m(-1). The highest total field exposure occurred for mobile scenarios (inside a train or bus) from uplink signals of GSM and DCS (e.g., mobile phones) due to changing environmental conditions, handovers, and higher required transmitted signals from mobile phones due to penetration through windows while moving. A method to relate the exposure to the actual whole-body absorption in the human body is proposed. An application is shown where the actual absorption in a human body model due to a GSM downlink signal is determined. Fiftieth, 95th, and 99 th percentiles of the whole-body specific absorption rate (SAR) due to this GSM signal of 0.58 microW kg(-1), 2.08 microW kg(-1), and 5.01 microW kg(-1) are obtained for a 95th percentile of 0.26 V m(-1). A practical usable function is proposed for the relation between the whole-body SAR and the electric fields. The methodology of this paper enables epidemiological studies to make an analysis in combination with both electric field and actual whole-body SAR values and to compare exposure with basic restrictions.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.