No abstract

No abstract

No abstract

No abstract

No abstract

This paper presents some of the experimental results from a study conducted to demonstrate the potential use of photocatalytic oxidation for decolorization and COD reduction of wastewater from 5–fluorouracil manufacturing. A series of batch experiments, were carried out using diluted solutions of the wastewater with 0.1 percent w/v TiO2. Low pressure mercury lamps were used to simulate the UV part of sunlight. The experiments showed that a complete decolorization and a substantial reduction of COD was achieved within 20 hours with a 20 percent solution. During the reaction period, the pH was noted to decrease considerably, indicating formation of acids. Adding hydrogen peroxide to the solution was found to significantly increase the reaction rates. Adding 2400 ppm of H2O2 gave an 80 percent decrease in color in one hour and a 70-80 percent decrease in COD in 20 hours. The influence of UV-light intensity was also examined. This experiment showed that with a UV-intensity of 15 W/m2, i.e., a cloudy day, the decolorization rate was still considerable, while the COD reduction rate was very low.

No abstract

This paper is a presentation of systematic study on externally fired gas turbine cogeneration fueled by biomass. The gas turbine is coupled in series with a biomass combustion furnace in which the gas turbine exhaust is used to support combustion. Three cogeneration systems have been simulated. They are systems without a gas turbine, with a non top-fired gas turbine, and a top-fired gas turbine. For all systems, three types of combustion equipment have been selected: circulating fluidized bed (CFB) boiler, grate fired steam boiler and grate fired hot water boiler. The sizes of biomass furnaces have been chosen 20 MW and 100 MW fuel inputs. The total efficiencies based on electricity plus process heat, electrical efficiencies, and the power-to-heat ratios for various alternatives have been calculated. For each of the cogeneration systems, part load performance with varying biomass fuel input is presented. Systems with CFB boilers have a higher total efficiency and electrical efficiency than other systems when a top-fired gas turbine is added. However, the systems with grate fired steam boilers allow higher combustion temperature in the furnace than CFB boilers do. Therefore, a top combustor may not be needed when high temperature is already available. Only one low grade fuel system is then needed and the gas turbine can operate with very clean working medium.