Abstract-This paper proposes a low cost and complexity indoor location and navigation system using visible light communications and a mobile device. LED lamps work as beacons transmitting an identifier code so a mobile device can know its location. Experimental designs for transmitter and receiver interfaces are presented and potential applications are discussed.
In this work, a novel current metering device was presented. This device was intended to bring current metering capabilities to a wide variety of scenarios: Developing countries, rural areas, or any situation with technological constraints. The device was designed to provide a straightforward installation with no intrusion in the electrical panels. This was achieved by applying energy harvesting techniques and wireless communication technology for data transmission. The device was able to exploit the magnetic field inducted around a wire carrying electricity as energy harvesting, thus acquiring the power it needed to work. Since very low power was harvested, an efficient treatment for the incoming power and a minimal power consumption system were essential. Although exploiting the magnetic fields inducted around a wire has been used for years, the combination of this technology for both energy harvesting and current metering in an end-user device was off-center. To work in a wide variety of scenarios, it used Sigfox for communications as this brought wide coverage and out-of-the-box functioning. The theoretical design of the device was validated by verification assessments for the joint performance of the individual parts compounding the device, including metering capabilities and wireless communication test-bench. Finally, the metering device was tested under three distinct real-world scenarios that demonstrated the viability of the system. Results show that, depending on the metering period and the average current value in the mains line, the device could work forever acquiring and sending electricity consumption data. Perpetual working was achieved with an average current of 3.1 A to meter every 15 min, and an average current of 5 A for a 5-min metering period.
Treatment of an isoenzyme of potato apyrase of high adenosine triphosphatase/adenosine diphosphatase (ATPase/ADPase) ratio with iodine, N-acetylimidazole or tetranitromethane inactivates the ATPase activity of this enzyme faster than its ADPase activity. There was protection by substrates with the two last-named substances. This and the appearance of nitrotyrosine suggests the participation of tyrosyl residues in both enzymic activities of potato apyrase. The participation of thiol groups is excluded by the insensitivity of apyrase to p-chloromercuribenzoate. Also, 2-hydroxy-5-nitrobenzyl bromide or carboxymethylation produce the same rate of inactivation of ATPase and ADPase activities. Substrates protect both activities from inactivation. Hydrogen peroxide and photo-oxidation inactivate ATPase activity faster than ADPase activity. There is no protection by substrates. Analysis of pH effects on V(max.) and K(m) suggest different pK values for the amino acid residues at the ATP and ADP sites.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.