Most mute people cannot speak due to their vocal cord lesion. Herein, to assist mute people to “speak”, we proposed a wearable skinlike ultrasensitive artificial graphene throat (WAGT) that integrated both sound/motion detection and sound emission in single device. In this work, the growth and patterning of graphene can be realized at the same time, and a thin poly(vinyl alcohol) film with laser-scribed graphene was obtained by a water-assisted transferring process. In virtue of the skinlike and low-resistant substrate, the WAGT has a high detection sensitivity (relative resistance changes up to 150% at 133 Ω) and an excellent sound-emitting ability (up to 75 dB at 0.38 W power and 2 mm distance). On the basis of the excellent mechanical-electrical performance of graphene structure, the sound detecting and emitting mechanisms of WAGT are realized and discussed. For sound detection, both the motion of larynx and vibration of vocal cord contribute to throat movements. For sound emission, a thermal acoustic model for WAGT was established to reveal the principle of sound emitting. More importantly, a homemade circuit board was fabricated to build a dual-mode system, combining the detection and emitting systems. Meanwhile, different human motions, such as strong and small throat movements, were also detected and transformed into different sounds like “OK” and “NO”. Therefore, the implementation of these sound/motion detection acoustic systems enable graphene to achieve device-level applications to system-level applications, and those graphene acoustic systems are wearable for its miniaturization and light weight.
MXenes have attracted great attention for their potential applications in electrochemical and electronic devices due to their excellent characteristics. Traditional sound sources based on the thermoacoustic effect demonstrated that a conductor needs to have an extremely low heat capacity and high thermal conductivity. Hence, a thin MXene film with a low heat capacity per unit area (HCPUA) and special layered structure is emerging as a promising candidate to build loudspeakers. However, the use of MXenes in a sound source device has not been explored. Herein, we have successfully prepared sound source devices on an anodic aluminum oxide (AAO) and a flexible polyimide (PI) substrates by using the prepared Ti3C2 MXene nanoflakes. Due to the larger interlayer distance of MXene, the MXene-based sound source device has a higher sound pressure level (SPL) than that of graphene of the same thickness. High-quality Ti3C2 MXene nanoflakes were fabricated by selectively etching the Ti3AlC2 powder. The as-fabricated MXene sound source device on an AAO substrate exhibits a higher SPL of 68.2 dB (f = 15 kHz) and has a very stable sound spectrum output with frequency varying from 100 Hz to 20 kHz. A theoretical model has been built to explain the mechanism of the sound source device on an AAO substrate, matching well with the experimental results. Furthermore, the MXene sound source device based on a flexible PI substrate has been attached to the arms, back of the hand, and fingers, indicating an excellent acoustic wearability. Then, the MXene film is packaged successfully into a commercial earphone case and shows an excellent performance at high frequencies, which is very suitable for human audio equipment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.