From first-principles calculations, the effects of h-BN and AlN substrates on the topological nontrivial properties of stanene are studied with different strains. We find that the quantum spin Hall phase can be induced in stanene film on a h-BN substrate under a tensile strain of between 6.0% and 9.3% with a stable state confirmed by the phonon spectrum, while for stanene on 5 × 5 h-BN, the quantum spin Hall phase can be preserved without strain. However, for stanene on a AlN substrate, the quantum spin Hall phase cannot be found under compressive or tensile strains less than 10%, while for 2 × 2 stanene on 3 × 3 AlN, the compressive strain needed to induce the quantum spin Hall phase is just 2%. These theoretical results will be helpful in understanding the effect of substrate and strain on stanene and in further realizing the quantum spin Hall effect in stanene on semiconductor substrates.

Based on first-principles calculations, the electronic and topological properties of halogenated (F-, Cl-, Br- and I-) arsenene are investigated in detail. It is found that the halogenated arsenene sheets show Dirac type characteristic in the absence of spin-orbital coupling (SOC), whereas energy gap will be induced by SOC with the values ranging from 0.194 eV for F-arsenene to 0.255 eV for I-arsenene. Noticeably, these four newly proposed two-dimensional (2D) systems are verified to be quantum spin Hall (QSH) insulators by calculating the edge states with obvious linear cross inside bulk energy gap. It should be pointed out that the large energy gap in these 2D materials consisted of commonly used element is quite promising for practical applications of QSH insulators at room temperature.

A nontoxic, simple, inexpensive, and reproducible strategy, which meets the standard of green chemistry, is introduced for the synthesis of copper nanocrystals (Cu NCs) with olive oil as both reducing agent and capping agent. By changing the reaction parameters, the shape, size and surface structure of the Cu NCs can be well controlled. The obtained Cu nanocubes show excellent catalytic properties for the catalytic reduction of dyes and CO oxidation. Moreover, the prepared Cu nanocubes as substrates exhibit surface enhanced Raman scattering (SERS) activity for 4-mercaptopyridine (4-Mpy). Therefore, this facile route provides a useful platform for the fabrication of Cu NCs which have the potential to replace noble metals for certain applications.

Heterostructure material that acts as resonant tunneling system is a major scientific challenge in applied physics. Herein, we report a resonant tunneling system, quasi-2D Cu2O/SnO2 p-n heterostructure multi-layer film, prepared by electrochemical deposition in a quasi-2D ultra-thin liquid layer. By applying a special half-sine deposition potential across the electrodes, Cu2O and SnO2 selectively and periodically deposited according to their reduction potentials. The as-prepared heterostructure film displays excellent sensitivity to H2S at room temperature due to the resonant tunneling modulation. Furthermore, it is found that the laser illumination could enhance the gas response, and the mechanism with laser illumination is discussed. It is the first report on gas sensing application of resonant tunneling modulation. Hence, heterostructure material act as resonant tunneling system is believed to be an ideal candidate for further improvement of room temperature gas sensing.

A novel method was developed to prepare zinc blende structure CdS: Co diluted magnetic semiconductor nanocrystals. The prepared samples display ferromagnetic behavior with a crystal size of about 3-4 nm. First-principle calculations show the phenomenon of ferromagnetism in CdS:Co nanocrystals arising not only from the Co atoms, but also from the Cd vacancies, with Co atoms being the major contributor. The introduction of Co atoms into CdS significantly reduces the formation energy of Cd vacancies, producing a lot of vacancies which enhance the ferromagnetism of the samples as a whole.