No abstract

No abstract

The Organisation for Economic Co-Operation and Development Test Guideline 488 (TG 488) uses transgenic rodent models to generate in vivo mutagenesis data for regulatory submission. The recommended design in TG 488, 28 consecutive daily exposures with tissue sampling three days later (28 + 3d), is optimized for rapidly proliferating tissues such as bone marrow (BM). A sampling time of 28 days (28 + 28d) is considered more appropriate for slowly proliferating tissues (e.g., liver) and male germ cells. We evaluated the impact of the sampling time on mutant frequencies (MF) in the BM of MutaMouse males exposed for 28 days to benzo[a]pyrene (BaP), procarbazine (PRC), isopropyl methanesulfonate (iPMS), or triethylenemelamine (TEM) in dose–response studies. BM samples were collected + 3d, + 28d, + 42d or + 70d post exposure and MF quantified using the lacZ assay. All chemicals significantly increased MF with maximum fold increases at 28 + 3d of 162.9, 6.6, 4.7 and 2.8 for BaP, PRC, iPMS and TEM, respectively. MF were relatively stable over the time period investigated, although they were significantly increased only at 28 + 3d and 28 + 28d for TEM. Benchmark dose (BMD) modelling generated overlapping BMD confidence intervals among the four sampling times for each chemical. These results demonstrate that the sampling time does not affect the detection of mutations for strong mutagens. However, for mutagens that produce small increases in MF, sampling times greater than 28 days may produce false-negative results. Thus, the 28 + 28d protocol represents a unifying protocol for simultaneously assessing mutations in rapidly and slowly proliferating somatic tissues and male germ cells.

BackgroundMicroarray normalizations typically apply methods that assume absence of global transcript shifts, or absence of changes in internal control features such as housekeeping genes. These normalization approaches are not appropriate for focused arrays with small sets of genes where a large portion may be expected to change. Furthermore, many microarrays lack control features that can be used for quality assurance (QA). Here, we describe a novel external control series integrated with a design feature that addresses the above issues.ResultsAn EC dilution series that involves spike-in of a single concentration of the A. thaliana chlorophyll synthase gene to hybridize against spotted dilutions (0.000015 to 100 μM) of a single complimentary oligonucleotide representing the gene was developed. The EC series is printed in duplicate within each subgrid of the microarray and covers the full range of signal intensities from background to saturation. The design and placement of the series allows for QA examination of frequently encountered problems in hybridization (e.g., uneven hybridizations) and printing (e.g., cross-spot contamination). Additionally, we demonstrate that the series can be integrated with a LOWESS normalization to improve the detection of differential gene expression (improved sensitivity and predictivity) over LOWESS normalization on its own.ConclusionThe quality of microarray experiments and the normalization methods used affect the ability to measure accurate changes in gene expression. Novel methods are required for normalization of small focused microarrays, and for incorporating measures of performance and quality. We demonstrate that dilution of oligonucleotides on the microarray itself provides an innovative approach allowing the full dynamic range of the scanner to be covered with a single gene spike-in. The dilution series can be used in a composite normalization to improve detection of differential gene expression and to provide quality control measures.

No abstract