The effect of pH on the complex formation between poly(acrylic acid) (PAA) and poly(ethylene oxide) (PEO) has been studied in aqueous solutions by turbidimetric and fluorescent methods. It was shown that the formation of insoluble interpolymer complexes is observed below a certain critical pH of complexation (pH(crit1)). The formation of hydrophilic interpolymer associates is possible above pH(crit1) and below a certain pH(crit2). The effects of polymer concentrations in solution and PEO molecular weight as well as inorganic salt addition on these critical pH values were studied. The polymeric films based on blends of PAA and PEO were prepared by casting from aqueous solutions with different pHs. These films were characterized by light transmittance measurements and differential scanning calorimetry. The existence of the pH value above which the polymers form an immiscible blend was demonstrated. The transitions between the interpolymer complex, miscible blend, and immiscible blend caused by pH changes are discussed. The recommendations for preparation of homogeneous miscible films based on compositions of poly(carboxylic acids) and various nonionic water-soluble polymers are presented.

A novel approach has been developed to synthesize thiolated sub-100 nm organosilica nanoparticles from 3-mercaptopropyltrimethoxysilane (MPTS) through its self-condensation in dimethylsulfoxide in contact with atmospheric oxygen. The formation of MPTS nanoparticles proceeds through the condensation of methoxysilane groups and simultaneous disulfide bridging caused by partial oxidation of thiol groups. These nanoparticles showed excellent colloidal stability in dilute aqueous dispersions but underwent further self-assembly into chains and necklaces at higher concentrations. They exhibited very good ability to adhere to ocular mucosal surfaces, which can find applications in drug delivery. The thiolated nanoparticles could also be easily modified through PEGylation resulting in a loss of their mucoadhesive properties.

The effect of inorganic salts addition on the complex formation of poly(acrylic acid) with various non‐ionic polymers such as poly(vinyl pyrrolidone), poly(acrylamide), poly(ethylene oxide), pol(vinyl methyl ether), poly(vinyl alcohol), poly(N‐isopropylacrylamide), poly(2‐hydroxyethyl vinyl ether), hydroxypropylcellulose and hydroxyethylcellulose has been studied in aqueous solutions. It was found that, depending on the nature of the polymers and pH medium, addition of inorganic salts could increase or decrease the critical pH values of complexation. A new classification of interpolymer complexes based on critical pH values and ionic strength effects is suggested. Copyright © 2004 Society of Chemical Industry

Free-radical copolymerization of 2-hydroxyethyl methacrylate with 2-hydroxyethyl acrylate can be successively utilized for the synthesis of water-soluble polymers and hydrogels with excellent physicochemical properties, thus showing promise for pharmaceutical and biomedical applications. In the work presented it has been demonstrated that water-soluble copolymers based on 2-hydroxyethyl methacrylate and 2-hydroxyethyl acrylate exhibit lower critical solution temperature in aqueous solutions, whereas the corresponding high molecular weight homopolymers do not have this unique property. The temperature-induced transitions observed upon heating the aqueous solutions of these copolymers proceed via liquid-liquid phase separation. The hydrogels were also synthesized by copolymerizing 2-hydroxyethyl methacrylate and 2-hydroxyethyl acrylate in the absence of a bifunctional cross-linker. The cross-linking of these copolymers during copolymerization is believed to be due to the presence of bifunctional admixtures or transesterification reactions. Transparency, swelling behavior, mechanical properties, and porosity of the hydrogels are dependent upon the monomer ratio in the copolymers. Hydrogel samples containing more 2-hydroxyethyl methacrylate are less transparent, have lower swelling capacity, higher elastic moduli, and pores of smaller size. The assessment of the biocompatibility of the copolymers using the slug mucosal irritation test revealed that they are also less irritant than poly(acrylic acid).

No abstract