In this paper, we establish a benchmark data set of a generic high-pressure (HP) turbine vane generated by direct numerical simulation (DNS) to resolve fully the flow. The test conditions for this case are a Reynolds number of 0.57 × 106 and an exit Mach number of 0.9, which is representative of a modern transonic HP turbine vane. In this study, we first compare the simulation results with previously published experimental data. We then investigate how turbulence affects the surface flow physics and heat transfer. An analysis of the development of loss through the vane passage is also performed. The results indicate that freestream turbulence tends to induce streaks within the near-wall flow, which augment the surface heat transfer. Turbulent breakdown is observed over the late suction surface, and this occurs via the growth of two-dimensional Kelvin–Helmholtz spanwise roll-ups, which then develop into lambda vortices creating large local peaks in the surface heat transfer. Turbulent dissipation is found to significantly increase losses within the trailing-edge region of the vane.

The validity of the Boussinesq approximation in the wake behind a high-pressure turbine blade is explored. We probe the mathematical assumptions of such a relationship by employing a least-squares technique. Next, we use an evolutionary algorithm to modify the anisotropy tensor a priori using highly resolved LES data. In the latter case we build a non-linear stress-strain relationship. Results show that the standard eddy-viscosity assumption underpredicts turbulent diffusion and is theoretically invalid. By increasing the coefficient of the linear term, the farwake prediction shows minor improvement. By using additional non-linear terms in the stress-strain coupling relationship, created by the evolutionary algorithm, the near-wake can also be improved upon. Terms created by the algorithm are scrutinized and the discussion is closed by suggesting a tentative non-linear expression for the Reynolds stress, suitable for the wake behind a high-pressure turbine blade.

No abstract

Machine learning was applied to large-eddy simulation (LES) data to develop nonlinear turbulence stress and heat flux closures with increased prediction accuracy for trailing-edge cooling slot cases. The LES data were generated for a thick and a thin trailing-edge slot and shown to agree well with experimental data, thus providing suitable training data for model development. A gene expression programming (GEP) based algorithm was used to symbolically regress novel nonlinear explicit algebraic stress models and heat-flux closures based on either the gradient diffusion or the generalized gradient diffusion approaches. Steady Reynolds-averaged Navier–Stokes (RANS) calculations were then conducted with the new explicit algebraic stress models. The best overall agreement with LES data was found when selecting the near wall region, where high levels of anisotropy exist, as training region, and using the mean squared error of the anisotropy tensor as cost function. For the thin lip geometry, the adiabatic wall effectiveness was predicted in good agreement with the LES and experimental data when combining the GEP-trained model with the standard eddy-diffusivity model. Crucially, the same model combination also produced significant improvement in the predictive accuracy of adiabatic wall effectiveness for different blowing ratios (BRs), despite not having seen those in the training process. For the thick lip case, the match with reference values deteriorated due to the presence of large-scale, relative to slot height, vortex shedding. A GEP-trained scalar flux model, in conjunction with a trained RANS model, was found to significantly improve the prediction of the adiabatic wall effectiveness.