No abstract

No abstract

No abstract

No abstract

No abstract

The as-synthesized TiO nanorods a-TNR (amorphous TiO layer covering the crystalline anatase TiO core) and TNR (fully crystalline anatase TiO) were decorated with reduced graphene oxide (rGO) to synthesize two series of TiO + rGO composites with different nominal loadings of GO (from 4 to 20 wt%). The structural, surface and electronic properties of the obtained TiO + rGO composites were analyzed and correlated to their performance in the photocatalytic oxidation of aqueous bisphenol A solution. X-ray photoelectron spectroscopy (XPS) analyses revealed that charge separation in TiO + rGO composites is improved due to the perfect matching of TiO and rGO valence band maxima (VBM). Cyclic voltammetry (CV) experiments revealed that the peak-to-peak separations (ΔE) are the lowest and the oxidation current densities are the highest for composites with a nominal 10 wt% GO content, meaning that it is much easier for the charge carriers to percolate through the solid, resulting in improved charge migration. Due to the high charge carrier mobility in rGO and perfect VBM matching between TiO and rGO, the electron-hole recombination in composites was suppressed, resulting in more electrons and holes being able to participate in the photocatalytic reaction. rGO amounts above 10 wt% decreased the photocatalytic activity; thus, it is critical to optimize its amount in the TiO + rGO composites for achieving the highest photocatalytic activity. BPA degradation rates correlated completely with the results of the CV measurements, which directly evidenced improved charge separation and migration as the crucial parameters governing photocatalysis.

No abstract

Self-assembled surface layers of benzotriazole (BTAH), 2-mercaptobenzimidazole (2-MBI) and stearic acid (SA), were studied as protective layers for brasses (Cu10Zn and Cu40Zn) and Zn in simulated urban rain (pH¼5). Layers were formed by immersion of samples in ethanol solution of organic inhibitors BTAH, 2-MBI and SA. The results of weight loss immersion tests, polarization measurements and electrochemical impedance measurements showed that SA layers provided the best long term corrosion protection of all tested inhibitors and exhibited the highest contact angles. 2-MBI provided less protection than SA. BTAH can be ruled out as a corrosion inhibitor under tested conditions, because it performed poorly upon long term immersion. In the cases of Cu40Zn and Zn it even promoted corrosion.